What to do if my JVC Minidisc Recorder is not recording?
If your JVC Minidisc Recorder isn't recording, there are a couple of potential reasons. Ensure you are using a recordable MD, as playback-only MDs cannot be used for recording. Also, check if the MD is write-protected; if “DISC PROTECTED” is displayed, slide the accidental erasure protect tab on the MD to the open position.
Why is the remote control not working on my JVC XM-EX90 Minidisc Recorder?
If the remote control isn't working with your JVC Minidisc Recorder, here are some things to check: 1. Make sure the batteries aren't exhausted and replace them if needed. 2. Verify the batteries are inserted with the correct polarity (+, –). 3. Ensure there are no obstacles between the remote control and the recorder's sensor. 4. Check if direct sunlight is interfering with the remote control sensor; if so, shield the sensor from the sunlight.
How to fix abnormal operation of JVC Minidisc Recorder?
If your JVC Minidisc Recorder is operating abnormally, it could be due to a couple of reasons. Condensation might have formed inside the unit, especially after a sudden temperature change. In this case, unplug the power cord, wait a few hours, and then plug it back in. Alternatively, the microcomputer might be malfunctioning due to external noise or lightning. Try unplugging the power cord and then plugging it back in to reset it.
General| Laser | Semiconductor laser |
|---|---|
| Sampling Frequency | 44.1 kHz |
| Display | LCD |
| Recording Format | MiniDisc |
| Playback Format | MiniDisc |
| Coding | ATRAC |
| Digital Input | Optical |
| Digital Output | Optical |
| Analog Input | Line-in |
| Analog Output | Line-out |
| Headphone Output | Yes |
| Wow and Flutter | Below measurable limit |
To Next Page
