USING THE REMOTE CONTROL CORRECTLY
Point the remote controller at the Remote Sensor.
The functions of the Buttons on the remote control are the same as the corresponding
controls on the main unit.
When there is a strong ambient light source, the performance of the infrared Remote Sensor
may be degraded, causing unreliable operation.
The maximum effective distance for remote control operation is about 5 metres (16.5 feet).
AUTOMATIC LEVEL CONTROL (ALC)
This has an automatic recording level control built into the cassette circuitry that is
electronically adjusted to control signal level from any source. therefore, recording is not
affected by the setting of the VOLUME or BASS BOOST button.
CASSETTE TAPE RECOMMENDATIONS
Standard tape lengths have 15 (C-30) and 30 (C-60) minutes of recording time on
each side. Longer length of 45 (C-90) and 60 (C-120) are available, but because longer
tapes in the same size packing need thinner materials, the chance for malfunction is much
greater. Longer Lenger tapes are not recommended. Use only high quality tapes. If
problem happens, try to use a new tape. If there is any slack in the cassette tape, insert a
pencil in the cassette hubs and rotate toward the outside of the cassette until the slack is
taken up.
SAFEGUARD AGAINST ACCIDENTAL ERASURE
To safeguard valuable recordings from being erased accidentally, there is an erasure
prevention tab on each side of the cassette. To prevent accidental erasing, break out the
tab with a screwdirver.
To record on a cassette with the tab broken, place a piece of adhesive tape over that hole.
NOTE: When a tab is broken out, the RECORD button cannot be depressed
9
004AV1R.p65 2004/2/10, PM 04:079
To Next Page
Loading...
Need help?
General
