Jydepejsen Trendline 1+2+3 User Manual (English)

Questions and Answers:

H
harolddavisJul 30, 2025
Why is there insufficient draft in my Jydepejsen Wood stove?
- A
  Amanda OliverJul 30, 2025
  Insufficient draft in your Jydepejsen Wood stove can occur for several reasons. First, ensure that the flue vent is open. Other potential causes include a defective or missing access hatch in the chimney, a chimney blocked by a bird's nest, a sooted flue pipe, or a chimney that's too small. In such cases, contact your chimney sweep/stove dealer for advice or clean the flue pipe and firebox. The baffle plate may also be incorrectly positioned, so check its fitting according to the operating instructions. Finally, negative pressure in the house can cause this issue; increase the air supply to the room to address it.
M
Monica RobinsonAug 3, 2025
Why is the glass pane sooting up on my Jydepejsen Wood stove?
- S
  Steven HumphreyAug 3, 2025
  The glass pane of your Jydepejsen Wood stove may be sooting up because the wood you're using is too wet. Use dry wood with a maximum moisture content of 20%. Also, ensure that the air vent is sufficiently open to supply more air for combustion.
D
David SummersAug 8, 2025
How to reduce draft in Jydepejsen Wood stove?
- C
  carlosschneiderAug 8, 2025
  Too much draft in your Jydepejsen Wood stove can be caused by several factors. The baffle plate might be incorrectly positioned, so check its fitting according to the operating instructions. If you're using kiln-dried wood, it requires less air than normal wood, so reduce the air supply. Also, if the air vent is constantly wide open, reduce the air supply. Check the sealing strips on the door; if they are worn, replace them as described in the operating instructions. Finally, the chimney might be too large; contact your chimney sweep/stove dealer for further advice.
B
Brett RobertsAug 12, 2025
What to do if smoke comes out when I open my Jydepejsen Trendline 1+2+3 Wood stove?
- B
  bjohnsonAug 12, 2025
  If smoke comes out into the room when you open the door of your Jydepejsen Wood stove, it could be due to pressure compensation occurring in the firebox. To resolve this, open the air vent wide for about 1 minute before opening the door, and avoid opening the door rapidly. Another potential cause is that the chimney is not a suitable size for the firebox. Check the height of the chimney, as it may be too short for the minimum draught required.
R
Raymond PalmerAug 16, 2025
Why is my Jydepejsen Wood stove producing white smoke?
- J
  Jason KnightAug 16, 2025
  White smoke from your Jydepejsen Wood stove can occur if the combustion temperature is too low; increase the air supply to address this. It can also happen if the wood is too damp and contains water vapor; always ensure that you use pure, dry wood in your stove.
S
Sherry RodriguezAug 21, 2025
What causes clouded glass on my Jydepejsen Trendline 1+2+3?
- R
  rmacdonaldAug 21, 2025
  Clouded glass or white film on your Jydepejsen Wood stove can be caused by poor combustion due to too low a temperature in the stove. Follow the instructions for correct burning as specified in this manual. It can also be due to incorrect combustion, such as burning waste wood, painted wood, impregnated wood, laminated plastic, plywood, or similar materials. Ensure that you use pure, dry wood in your stove.
R
Ronald ElliottAug 26, 2025
Why is my Jydepejsen Trendline 1+2+3 producing black smoke?
- A
  Andrea FergusonAug 26, 2025
  Black or grayish-black smoke from your Jydepejsen Wood stove indicates incomplete combustion. Increase the air supply to address this issue.

Jydepejsen Trendline 1+2+3 Specifications

General

Category	Wood stove
Fuel	Wood
Smoke Outlet Diameter (mm)	150
Flue diameter (mm)	150
Material	Steel

Summary

Jydepejsen Stove Overview

Stove Installation Requirements

Details mandatory pre-installation checks, prohibitions, and site preparation requirements.

Minimum Clearances to Combustibles

Specifies minimum distances to walls, corners, and pipes for various installation configurations.

Cubic Series Assembly Diagrams

Illustrates installation and clearances for Cubic 109/166/215, Wall, and Corner models.

Trendline 2 Installation Procedures

Provides procedures for installing the Trendline 2 stove with or without the turntable feature.

Chimney and Connector Installation

Chimney Installation Components

Lists essential components required for proper chimney installation.

Chimney Connector Guidelines

Information on acceptable materials and installation of chimney connectors.

Chimney Connector Safety and Air Supply

Prohibits connecting the stove to ductwork and emphasizes fresh air supply.

Chimney Connector Clearances to Combustibles

Details clearances for brick, insulated factory-built, and sheet steel chimney connectors.

Heat Generation and Distribution

Radiant vs. Convection Heat

Explains the two major types of heat: radiant and convection, and their distribution.

Combustion Air Supply

Emphasizes the need for sufficient combustion air, including outdoor air supply.

Stove Paint Curing Process

Describes the initial curing of stove paint, smoke, and odor during first fires.

Stove Material Expansion

Notes normal creaking noises from stove expansion and contraction during heating cycles.

Sensible Wood Burning Practices

Wood Burning Process Stages

Details the stages of wood burning, from drying to charcoal combustion.

Overheating Warning and Warranty

Warns against overheating, which can cause irreparable damage not covered by warranty.

Prohibited Fuels and Materials

Lists materials like chemicals, garbage, and treated wood that must not be burned.

Incorrect Wood Burning Practices

Explains issues from too much air, rapid heating, and overfilling the firebox.

Technical Information on Wood Burning

Fuel Types and Heating Values

Compares the heating values of different wood types.

Fuel Quality and Seasoning

Details requirements for pure, dry wood and the seasoning process.

Creosote Formation and Removal

Explains creosote formation, inspection, and removal to prevent chimney fires.

Air Supply and Combustion Systems

Preheated Air Combustion Technology

Describes the stove's preheated air system for rapid combustion temperature.

Startup and Primary Air Supply

Explains the function of startup and primary air vents for lighting and control.

Jydepejsen DuplicAir System

Details how startup and primary air are combined in the DuplicAir system.

Secondary and Direct Air Systems

Secondary Air System

Explains secondary air holes in baffle plates for improved gas combustion.

Direct Air System

Describes direct air for cleaner, efficient combustion and maintaining embers.

First Fire Preparation

Pre-lighting Checks and Ventilation

Covers initial precautions, baffle handling, and ventilation during first firing.

Fire Building Method

Instructs to build fire directly on hearth, not using grates.

Stove Lighting Procedure

Stove Refueling Instructions

Stove Troubleshooting Guide

Draft and Smoke Issues

Addresses draft problems, smoke emission, and coloration issues.

Glass Sooting and Clouding

Provides solutions for sooting glass panes due to wet wood or insufficient air.

Stove Maintenance Procedures

Gasket and Vermiculite Panel Replacement

Guidance on replacing worn gaskets and vermiculite panels for optimal performance.

Door and Glass Maintenance

Instructions for inspecting and cleaning door seals, glass panes, and ensuring airtightness.

Ash Disposal and Cleaning Guide

Proper procedures for collecting ashes and cleaning the stove and chimney.

External Stove and Cladding Maintenance

Ashpan Management and External Cleaning

Advice on ashpan management and cleaning the stove exterior.

Ceramic Tile and Soapstone Care

Details ceramic tile characteristics and provides instructions for soapstone care.

Door and Glass Gasket Replacement

Replacing Gaskets (Non-Cubic Models)

Step-by-step instructions for replacing door gaskets on models other than Cubic.

Replacing Gaskets (Cubic Series)

Instructions for replacing door gaskets on the Cubic series stoves.

Changing Vermiculite Panels

Product Warranty Information

Warranty Exclusions and Limitations

Lists items and conditions not covered by the warranty, such as wear parts and misuse.

Spare Parts List

Cubic Series Assembly Instructions

Cubic Wall Assembly

Instructions for preparing and fastening the Cubic Wall stove onto its furnishing.

Cubic Corner Assembly

Instructions for preparing and fastening the Cubic Corner stove onto its furnishing.

Cubic W200 and Model Adjustments

Cubic W200 Assembly

Steps for assembling the Cubic W200 stove, including cladding and fastening.

Cubic 109/166/215 Adjusting Screws

Information on adjusting Cubic 109, 166, and 215 stoves using adjusting screws.

Trendline Soapstone Cladding Assembly

Softline Cladding Assembly (Soapstone)

Softline Cladding Assembly (Ceramic)

Related product manuals

Jydepejsen Trend-line

Jydepejsen Trendline 1+2+3 User Manual

Table of Contents

Questions and Answers:

Jydepejsen Trendline 1+2+3 Specifications

Summary

Jydepejsen Stove Overview

Stove Installation Requirements

Minimum Clearances to Combustibles

Cubic Series Assembly Diagrams

Trendline 2 Installation Procedures

Chimney and Connector Installation

Chimney Installation Components

Chimney Connector Guidelines

Chimney Connector Safety and Air Supply

Chimney Connector Clearances to Combustibles

Heat Generation and Distribution

Radiant vs. Convection Heat

Combustion Air Supply

Stove Paint Curing Process

Stove Material Expansion

Sensible Wood Burning Practices

Wood Burning Process Stages

Overheating Warning and Warranty

Prohibited Fuels and Materials

Incorrect Wood Burning Practices

Technical Information on Wood Burning

Fuel Types and Heating Values

Fuel Quality and Seasoning

Creosote Formation and Removal

Air Supply and Combustion Systems

Preheated Air Combustion Technology

Startup and Primary Air Supply

Jydepejsen DuplicAir System

Secondary and Direct Air Systems

Secondary Air System

Direct Air System

First Fire Preparation

Pre-lighting Checks and Ventilation

Fire Building Method

Stove Lighting Procedure

Stove Refueling Instructions

Stove Troubleshooting Guide

Draft and Smoke Issues

Glass Sooting and Clouding

Stove Maintenance Procedures

Gasket and Vermiculite Panel Replacement

Door and Glass Maintenance

Ash Disposal and Cleaning Guide

External Stove and Cladding Maintenance

Ashpan Management and External Cleaning

Ceramic Tile and Soapstone Care

Door and Glass Gasket Replacement

Replacing Gaskets (Non-Cubic Models)

Replacing Gaskets (Cubic Series)

Changing Vermiculite Panels

Product Warranty Information

Warranty Exclusions and Limitations

Spare Parts List

Cubic Series Assembly Instructions

Cubic Wall Assembly

Cubic Corner Assembly

Cubic W200 and Model Adjustments

Cubic W200 Assembly

Cubic 109/166/215 Adjusting Screws

Trendline Soapstone Cladding Assembly

Softline Cladding Assembly (Soapstone)

Softline Cladding Assembly (Ceramic)

Related product manuals