EasyManua.ls Logo

Jydepejsen Trend-line - User Manual

Jydepejsen Trend-line
28 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Report # 301-S-02c-4
UL 1482(2010) and S627-00(2000)
- Read this manual carefully and save these instructions
Installation and user manual
Trendline 1+2+3
Troja 1+2+3
Softline
Fineline 1+2
Zeus
Athene
Hera
Avanti
Cubic 109-166-215
Cubic Corner
Cubic Wall
Cubic W200
Cosmo Models
Manufactured by:
Ahornsvinget 3-7 DK-7500 Holstebro
T.+45 96101200 F.+45 97425216
www.jydepejsen.com
Imported by:
PO Box 120 Pound Ridge NY 10576
T.914-764-5679 F.914-764-0465
www.wittus.com

Table of Contents

Other manuals for Jydepejsen Trend-line

Preview: Operating Instructions
Operating Instructions40 pages

Questions and Answers

  • V
    Veronica NicholsAug 8, 2025
    Why is there insufficient draft in my Jydepejsen Trend-line Wood stove?
    • R
      Ronald MonroeAug 8, 2025
      Insufficient draft in your Jydepejsen Wood stove can occur for several reasons. First, ensure that the flue vent is open. Other potential causes include a defective or missing access hatch in the chimney, a chimney blocked by a bird's nest, a sooted flue pipe, or a chimney that's too small. In such cases, contact your chimney sweep/stove dealer for advice or clean the flue pipe and firebox. The baffle plate may also be incorrectly positioned, so check its fitting according to the operating instructions. Finally, negative pressure in the house can cause this issue; increase the air supply to the room to address it.
  • H
    huberjuanAug 12, 2025
    Why is the glass pane sooting up on my Jydepejsen Trend-line Wood stove?
    • F
      Felicia WarrenAug 12, 2025
      The glass pane of your Jydepejsen Wood stove may be sooting up because the wood you're using is too wet. Use dry wood with a maximum moisture content of 20%. Also, ensure that the air vent is sufficiently open to supply more air for combustion.
  • C
    Carl Harris IIIAug 17, 2025
    How to reduce draft in Jydepejsen Trend-line?
    • M
      Matthew MccarthyAug 17, 2025
      Too much draft in your Jydepejsen Wood stove can be caused by several factors. The baffle plate might be incorrectly positioned, so check its fitting according to the operating instructions. If you're using kiln-dried wood, it requires less air than normal wood, so reduce the air supply. Also, if the air vent is constantly wide open, reduce the air supply. Check the sealing strips on the door; if they are worn, replace them as described in the operating instructions. Finally, the chimney might be too large; contact your chimney sweep/stove dealer for further advice.
  • J
    John CruzAug 20, 2025
    What to do if smoke comes out when I open my Jydepejsen Trend-line Wood stove?
    • J
      jacobvalentineAug 21, 2025
      If smoke comes out into the room when you open the door of your Jydepejsen Wood stove, it could be due to pressure compensation occurring in the firebox. To resolve this, open the air vent wide for about 1 minute before opening the door, and avoid opening the door rapidly. Another potential cause is that the chimney is not a suitable size for the firebox. Check the height of the chimney, as it may be too short for the minimum draught required.
  • T
    Tiffany SandersAug 26, 2025
    Why is my Jydepejsen Trend-line Wood stove producing white smoke?
    • G
      gonzalezalanAug 26, 2025
      White smoke from your Jydepejsen Wood stove can occur if the combustion temperature is too low; increase the air supply to address this. It can also happen if the wood is too damp and contains water vapor; always ensure that you use pure, dry wood in your stove.
  • M
    Michael MorganAug 29, 2025
    What causes clouded glass on my Jydepejsen Trend-line?
    • C
      Craig BellAug 29, 2025
      Clouded glass or white film on your Jydepejsen Wood stove can be caused by poor combustion due to too low a temperature in the stove. Follow the instructions for correct burning as specified in this manual. It can also be due to incorrect combustion, such as burning waste wood, painted wood, impregnated wood, laminated plastic, plywood, or similar materials. Ensure that you use pure, dry wood in your stove.
  • H
    Henry BerrySep 3, 2025
    Why is my Jydepejsen Trend-line Wood stove producing black smoke?
    • J
      James ChambersSep 3, 2025
      Black or grayish-black smoke from your Jydepejsen Wood stove indicates incomplete combustion. Increase the air supply to address this issue.

Jydepejsen Trend-line Specifications

General IconGeneral
CategoryWood stove
ManufacturerJydepejsen
ModelTrend-line
Heating capacity3-7 kW
Log length30 cm
Weight120 kg
Flue diameter150 mm
MaterialSteel

Related product manuals