KY102 Ver. 1.4
14
10. TECHNICAL SPECIFICATIONS
Notes for data
1. With dedicated preset;
2. Measured @8 mt then scaled @1 mt;
3. Measured with musical signal
New materials and design are introduced into existing products without previous notice.
Present systems may differ in some respects from those presented in this catalogue.
ACOUSTICS
Power handling
1200 W
Max power
1800 W
Frequency range
110 Hz – 20 kHz (- 3dB)
(1)
Impedance 8 Ω / 32 Ω (selectable)
SPL 1W/1mt
102 dB
(2)
Maximum SPL 132 dB (cont.) – 138 dB (peak)
(3)
COVERAGE
Horizontal
90°
Vertical
7° / 30° (selectable)
CROSSOVER
Type External crossover required
Frequency
High pass @ 90 Hz, 24 dB/oct suggested
minimum
TRANSDUCERS
Full range
8 x 4” Neodymium magnet cone drivers
with 1.5” voice coil
SELECTION SWITCHES
Impedance 8 Ω / 32 Ω
Coverage Spot / Flood
POWER AUDIO INPUT/OUTPUT
Connector 2 x 4-pin Speakon
Wiring 1+ 1- (signal IN & LINK); 2+ 2- (through)
RECOMMENDED AMPLIFIERS
Type KA84, KMT
CERTIFICATION
IP 54
PHYSICAL
Dimensions
11.6 x 100.0 x 13.4 cm
(4.6” x 39.4” x 5.3”)
Weight 14.9 kg (32.8 lbs)
The contents of this manual are furnished for informational purposes only. K-array s.u.r.l. assumes no responsibility for any errors or inaccuracies that may
appear in this manual. K-array s.u.r.l. reserves the right to make modifications without prior notice.
To Previous Page
Loading...
