Need help?Do you have a question about the K-array Tornado KT2 and is the answer not in the manual?
Details the 4-pin audio and 4-pin light connectors on KT2/KT2C models.
Explains the 32 Ohm wiring setup for specific K-array amplifiers like KA24.
Describes the 8 Ohm wiring setup for the KA1-T amplifier.
Wiring instructions for RGB LEDs using R, G, B, and V+ signals.
Steps for mounting KT2 and KT2L speakers on a wall using brackets.
Guide for installing KT2C and KTL2C speakers in ceiling tiles.
Diagram and explanation for connecting the KA1-T2H amplifier module.
Steps to contact K-array support and details for repair requests.
Instructions for safely cleaning the device housing without damage.
General| Frequency Response | 150 Hz – 18 kHz ±3dB |
|---|---|
| Impedance | 16 Ω |
| Dimensions | 79 x 79 x 100 mm (3.11 x 3.11 x 3.94 in) |
| Weight | 0.7 kg (1.54 lbs) |
| Crossover | Passive |
| Connectors | 2 x Speakon |
| Type | Passive line array speaker |
To Next Page
