K-Drill Ice Auger - Proper Auger-to-Drill Chucking; Storage & Maintenance

7
Owner’s Manual
Proper Auger-to-Drill Chucking
It is important to ensure that your K-Drill Auger is properly attached (chucked)
into your cordless drill. Look closely to ensure the drill bites the auger stem
properly on all three sides. Failure to do so will cause the auger to come lose as
well as stem stripping shown here.
Storage & Maintenance
Make sure to store the K-Drill auger in a safe location, and out of reach of
children and animals. MAKE SURE THE SAFETY COVER IS IN PLACE DURING
STORAGE!
Attheendoftheiceshingseasonbeforestoringforsummer,sprayWD-40on
the blades to prevent rusting during the off season.
New Stem Stripped Stem