5
Safety instructions
(continued)
In case of long periods of absence, vaca-
tion etc., the machine must be emptied,
cleaned and the power plug must be re-
moved from the socket.
If there is risk of frost, all residual wa-
ter must be removed, see the section on
“Evaporating residual water” on page 17.
The mains voltage must match the spec-
ifications on the type plate. Only con-
nect the machine to a grounded 3-pin
wall socket. If you connect the machine
incorrectly, you may lose your warranty
rights.
Do not damage the power cord by plac-
ing it on or near hot objects or over
sharp edges. Do not allow the power
cord to hang down (risk of tripping).
Do not touch the power cord with wet
hands. Do not remove the plug from the
socket by pulling on the cable. If the
power cord shows signs of damage, do
not start the machine.
If the power cord of the machine is dam-
aged, it must be replaced by the manu-
facturer, his company customer service
or a similarly qualified person in order to
avoid any hazards.
Do not place the machine on a hot sur-
face (e.g. cooker) or operate it next to
heat sources or fires. Do not allow the
machine to stand on its power cord. Al-
ways place the unit on a stable, level sur-
face that is water-resistant.
For health reasons, only fill the water
tank with fresh drinking water.
How to avoid injuries and scalds when
using the machine.
Do not leave the machine unattended
while a drink is being prepared.
This machine may be used by children
from the age of 8 years and older and by
persons with reduced physical, sensory
or mental abilities or who lack experi-
ence and knowledge in handling the ma-
chine, provided they are supervised or
have been instructed regarding the safe
operation of the machine, and under-
stand the resulting dangers.
To Next Page
Loading...
