Need help?Do you have a question about the K1EL WinKeyer3 and is the answer not in the manual?
General| Memory | 32KB Flash, 2KB SRAM, 1KB EEPROM |
|---|---|
| EEPROM | 1KB |
| Paddle Input | Yes |
| Flash Memory | 32KB |
| SRAM | 2KB |
| Straight Key Input | Yes |
| Microcontroller | Atmel ATmega328P |
| Interface | USB |
| Keying Speed | 5 to 99 WPM |
| Speed Range | 5 to 99 WPM |
| Supply Voltage | 5V |
| Operating Voltage | 5V DC |
| Outputs | Keying output, PTT output, Sidetone output |
| Power Supply | USB |
Lists key features and describes physical connections.
Information on installing necessary USB drivers for WKUSB.
Specifics on wiring keying and PTT outputs and USB connections.
Guides for using WKscan for port detection and WKdemo for testing.
Details on using WK3tools for managing settings and firmware.
How to use the message editor within the Winkeyer 3 Tools Utility.
Procedure to reset WKUSB to its default factory configurations.
Differentiates between standalone and host modes of operation.
Information on keying cables and their connection points.
Describes the path of data and commands within the WKUSB.
How paddle input takes precedence over host input.
Procedure to reset WKUSB to its original settings.
Configuration options within the Hardware and Winkey tabs of the N1MM+ configurer.
Adjusting various keyer parameters like mode, speed, and timing.
Using the CW Key window for testing.
Configuring DM780 for CW operation with WKUSB.
Setting up the Keyer tab in DM780's Winkeyer dialog.
Adjusting PTT enable, port selection, and sidetone options.
Configuring CW settings within the N3FJP AC Log software.
Configuring transmit settings in MRP40 to use WKUSB.
Instructions for downloading and installing the FTDI driver manually.
How to update drivers using Device Manager if installation fails.
How to view and reassign COM ports in Windows 7 and later.
Explanation of weighting and keying compensation parameters.
Definition of letterspace and paddle sample delay settings.
Details on PTT lead-in and tail delay settings for transmission control.
Description of the different keying modes available (Iambic, Straight Key, etc.).
Enabling Single Operator Two Radio (SO2R) mode.
How to enter and use command mode for standalone operation.
A list of available commands for standalone mode operation.
How to select different keying modes using the K command.
Command to retrieve the current WKUSB settings.
Setting the PTT tail time for transmission control.
Adjusting the keying weight parameter.
Switching between user configurations.
Using two-press sequences for message buttons.
Reference table for embedded message commands.
Methods for configuring and operating standalone beacons.
Saving current WKUSB settings to non-volatile memory.
Quick reference for standalone mode commands.
Guidance on creating messages for beacon operation.
To Next Page
