And-Go is ON), i.e. the accelerator only works if the scooter is already
in motion.
5. Mode Button. Press to select various display options:
Time since powering on the scooter.
Distance travelled since powering on the scooter.
Total distance travelled.
Charging mode. Time (2 hours) scooter stays ON (overrides auto-
switch off) so you can use display’s USB port to charge e.g. your phone.
Detailed P-settings mode. To access P-settings to make various advanced
changes, press POWER [3] and MODE [5] simultaneously for 2 seconds.
Cycle through the P-settings using the MODE button. To select a P-setting
in order to make changes press the POWER button. Change the value (up
or down) using the MODE (Up) and POWER (Down) buttons. To return to
the P-settings menu after changing a value, wait 2 seconds. To return to
operating mode, wait a further 2 seconds. Only
Tire diameter (10 = 10 inch). Do not change.
Controller shut-down voltage. Default set to 52V (minimum is 48V – we
recommend 52V to preserve battery life).
Motor magnetic pole setting. Default is 40. Do not change.
Speed signal selection. Default is 0. Do not change.
Distance / speed unit. 0=km, 1=miles
Start setting. 1=non-zero start (Kick-and-Go), accelerator won’t work if scooter
not in motion; 0=immediate start (CAUTION while using this!)
Cruise control. 0=cruise control OFF, 1=cruise control ON.
Initial acceleration. 0=strong, 1=soft.
Electric (regenerative) braking (E-ABS). 0=E-ABS off, 1=E-ABS on
Speed limit as % of top speed, i.e. 100=no speed limit.
Clear total distance travelled (ODO).
Scooter auto-turn off time in minutes.
Display brightness (1=low, 3=high)
To Next Page
Loading...
