7. Mode Button. Press to select various display options:
Time since powering on the scooter.
Distance travelled since powering on the scooter.
Total distance travelled.
Number of times battery has been charged (inaccurate as only full
discharges are counted)
Detailed P-settings mode. To access P-settings to make various advanced
changes, press MODE [7] for 2-3 seconds.
Cycle through the P-settings using the MODE button [7]. In order to change
a P-setting press GEAR button [4]. To return to operating mode, wait a few
seconds.
Tire diameter (10 = 10 inch). Do not change.
System voltage. Default 60V. Do not change.
Motor magnetic pole setting. Default 15. Do not change.
Speed signal selection. Default is 0. Do not change.
Distance / speed unit. 0=km, 1=miles
Start setting. 1=non-zero start (Kick-and-Go), accelerator won’t work if scooter
not in motion; 0=immediate start (CAUTION while using this!)
Cruise control. 0=cruise control OFF, 1=cruise control ON. Advanced riders
only.
Initial acceleration. 0=strong power, 5=least power.
Speed limit as % of top speed, i.e. 100=no speed limit.
Motor torque. 1=50% of max. torque, 2=75% of max. torque, 3=max. torque
Electric (regenerative) braking strength (E-ABS). 0=None, 1=Weak, 2=Medium,
3=strong.
Display brightness (0=off, 5=highest illumination)
Scooter auto-turn off time in minutes (1-30 minutes).
ABS (anti-lock braking system) setting. 0=ABS off, 1=ABS on (as in a car, the
brake engages and disengages rapidly to prevent the wheel from blocking)
WARNING: Due to increased vibration and force and on scooter components
when using ABS, do frequently check that all bolts are properly fastened.
To Next Page
Loading...
