Kaabo WOLF WARRIOR X - Page 9

15
Wolf Warrior X User Manual
16
Wolf Warrior X User Manual
How to use the instrument panel
WOLF WARRIOR X
Caution
COMMENT
TIME
TIME
Time since powering on the scooter.
TRIP
Distance travelled since powering on the scooter.
ODO
Total distance travelled.
VOL
Current battery voltage.
CH2:00
Charging mode. Time (2 hours) scooter stays ON (overrides auto
-switch off) so you can use the display’s USB port to also
charge things e.g. your phone.
P-
SETTINGS
P0
Tire diameter 10. Do not change.
P1
System voltage. Default 530 .Do not change.
P2
Motor magnetic pole setting. Default is 30. Do not change.
P3
Speed signal selection. Default is 0. Do not change.
P4
Distance / speed unit. 0=km, 1=miles
P5
Start setting. 1=non-zero start (Kick-and-Go), accelerator won’t work if scooter is not in motion; 0
=immediate start (CAUTION while using this)
P6
Cruise control. 0=cruise control OFF, 1=cruise control ON.
P7
Initial acceleration. 0=soft, 1=strong.
P8
Electric (regenerative) braking (E-ABS). 0=E-ABS off, 1=E-ABS on
PA
Clear total distance travelled (ODO).
PB
Scooter auto-turn off time in minutes.
PC
Display brightness (1=low, 2=medium, 3=high)
1.Speedometer: Shows the speed at which you are travelling.
2.Battery Indicator: Shows the level of your battery. Charge your scooter frequently, and
do not let it run out of battery. As a rough guideline, charge at or below 2 bars.
3.Power Button: To turn the scooter on or off press the button for 2 seconds.
4.Accelerator: Pull to accelerate. The stronger you pull, the faster it accelerates. The
scooter is delivered in “Non-Zero Start” setting (Kick-And-Go is ON), i.e. the accelerator
only works if the scooter is already in motion.
5.Mode Button: Press to select various display options:
Option 1:
Cruise Control. Cruise control allows you to maintain your driving speed automatically without continuing to
hold down the accelerator. In order to enter Cruise Control, activate it first in the P-settings [P6].
While driving, keep the accelerator steady for a few seconds until Cruise Control kicks in and scooter travels at a
constant speed without driver holding down the accelerator. When you activate the brakes Cruise Control will be
cancelled. CAUTION: Ride in a position where you can immediately access the brake to cancel Cruise Control if
necessary.
Option 2:
See the details in the attached maunal