2
RFID Wall Reader Installed with ILCO RAC 4 or RAC4XT Installation Guide - PK3660_07_16
Regulatory Compliance:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful inter ference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications of this product, not approved by manufacturer will void the user’s authority to operate the equipment.
“This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.”
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux condi-
tions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
FCC # Q8SR79KSR
IC# 4652A-R79KSR
*Caution*
WEAR SAFETY GLASSES WHILE PREPARING WALL
Introduction
The RFID wall mounted reader provided by Kaba is compact, lightweight, rugged and water resistant, able to withstand tempera-
tures from -30°F to 150°F (-35°C to 66°C). It is made from durable materials and comes with at least 15 feet (4.6 m) of cable. The
reader is capable of functioning up to distances of 500 feet (152.4 m) when powered from the RAC controller board.
The reader has a blue LED that indicates that the unit is powered. The reader also provides visual feedback when access is
granted.
RFID Wall Reader Instructions - (All Models)
SURFACE MOUNT
GANG BOX MOUNT
NARROW STILE MOUNT
(not available for Hilton BLE properties)
To Next Page
Loading...
Need help?
General
