Kaiser Baas Alpha Pro Drone - Faq

27 28
5. The Drone is out of control and is
dicult to y. How can I make it easier?
a. Prior to every ight we recommend you
calibrate the Drone.
To calibrate push the Left Throttle/Yaw
Stick and the Right Pitch/Roll Stick to
the bottom left and hold for 2 seconds
until you see the LED indicator lights on
the drone start to ash rapidly.
The Drone LEDS will stop ashing
when calibration is complete.
FAQ
1. The Drone LED lights are ashing.
What does this mean?
a. The Drone is not paired with a Remote
Control Transmitter. Refer to the Drone
Setup/Installation section.
b. The Drone has insucient battery
power. Please charge the Drone
battery.
2. The Drone’s Rotor Blades spin but
the Drone does not take-o?
a. Insucient Battery Power. If the Drone
LEDs are ashing and the Drone Rotor
blades are spinning without any lift,
recharge the Drone battery.
b. The Rotor Blades are distorted.
Replace them with only ocial Kaiser
Baas replacement blades.
3. Why is the Drone is shaking and not
stable in ight?
a. Please check to ensure the Rotor
Blades are not damaged. Refer to the
maintenance guide on Rotor Blade
care.
b. Check that all the motors are spinning.
Refer to the maintenance guide for
more information.
4. My Drone keeps tipping when I
take-o!
a. It is often dicult for new Pilots to get
used to the take-o procedure. To
take-o without tipping, give the Drone
a smooth lift of power with the Throttle,
rather than a quick movement. Once in
the air, keep the Drone level using the
Right Stick (Elevator/Aileron).