Kaliburn ProLine 2200 User Manual

ProLine 2200 Precision Plasma Cutting System
Revision N
10/15/2012
Manual Part Number 718063
This information is subject to the controls of the Export Administration
Regulations [EAR]. This information shall not be provided to non-U.S.
persons or transferred by any means to any location outside the United
States contrary to the requirements of the EAR.
N
REVISION

Kaliburn ProLine 2200 Specifications

General

Duty Cycle	60% at 200A
Welding Process	Plasma cutting
Output Power	2200W
Gas Requirements	Air or Nitrogen
Output Current Range	20-200A
Input Voltage	230/460 V

Summary

Safety

General Safety Precautions

General safety guidelines including radiation, noise, and fume hazards.

Electrical and Fire Safety

Guidelines for preventing electric shock, fire, and explosions during operation.

Specifications

Component Specifications

Installation

Initial Setup and Interconnection

Component Installation

Electrical and Gas Connections

Operation

Control Panel and Settings

Explanation of front panel controls, including power, gas, and current settings.

Cutting Procedures

Step-by-step guide for setting up and performing a plasma cut.

Cut Quality and Charts

Maintenance and Troubleshooting

Routine Maintenance

Troubleshooting Procedures

Methods for diagnosing and resolving system problems using status LEDs and error codes.

Component-Specific Tests