Supplementary guide | Pedelec Bosch Integrale 0.5 EN-25
3.13.3 Quick-release axle
*
Removing the front wheel
1. Remove the Pedelec battery.
2. Open the quick-release skewer on the
front wheel by turning it down 180˚.
You will now usually be able to see the
word ‘OPEN’ on the inside of the lever.
3. Hook the quick-release skewer into the slot and turn it anticlockwise
until the quick-release axle protrudes from the axle hole about 1 cm.
4. Lift out the front wheel and remove the quick-release axle.
PLEASE NOTE
Detach all cables from the wheel (e.g. lighting cables), otherwise you
could tear them.
5. Remove the front wheel.
Quick-release
skewer
For 2. Open the quick-release skewer
Replacing the front wheel
1. Apply a thin layer of grease to the quick-release axle.
2. Push the wheel into the front forks
and align with the axle holes.
3. Reinsert the quick-release axle.
4. Move the quick-release lever to the open position.
5. Hook the quick-release skewer into the slot and turn it clockwise.
This will screw the axle in the thread. Ensure that the wheel is
correctly centred.
6. Close the quick-release skewer by swinging the lever by 180˚. You will
now usually be able to see the word ‘CLOSE’ on the outside of the
lever.
DANGER
It should be so hard to close the quick-release skewer that you need
to use the balls of your hands (120 N: corresponds to a weight force
of 26.5 lb). You should have the mark of the lever imprinted on your
hand. Otherwise it could open when
you are cycling which could lead
to the wheel becoming loose and cause you to fall.
Quick-release
skewer
For 6. Close the quick-release skewer
*dependent on model
To Next Page
Loading...
