KAM KML305 - Initial Setting

6
Menu operating instruction
Initial Setting
ENTER into the next
step. To choose the
effect speed through
the UP/DOWN button.
S.01-S.99：
Effect speed adjustment.
01 is the slowest,
99 is the fastest
ENTER:
confirm and back
to the previous step.
AP01-AP17
PAR light auto show
Built-in
auto
programs
Rut
SP01-SP12
PAR light sound show
Built-in
sound
programs
SOU
Enter to confirm.
To adjust the sound sensitivity through the potentiometer.
ENTER into the next
step. MENU to
the previous step.
S.00—S.99：
strobe speed
S.00: all on,
S.99: the fastest
ENTER:
confirm and back
to the previous step.
R.000-R.255
G.000-G.255
B.000-B.255
COLO
color
setting
COL
Selecting the channel
d001-dXXX
Setting the address
03/04/12/20CH
DMX
mode
DNH
ENTER into the
next step
001-255 address setting
When selecting the
SLAVE mode, this
machine will follow
the master’s built-in
program through the
DMX cable.
SLAVE
mode
SLR
ENTER:
confirm and back
to the previous step.
ENTER into the
next step
ON：
turn on master mode
M-En: master mode
System
setting
sys
ENTER:
confirm and back
to the previous step.
ENTER into the
next step
ON：
turn on the wireless
footswitch working mode
W-En:
wireless pedal
working mode
ENTER:
confirm and back
to the previous step.
OFF：
turn off the wireless
footswitch working mode
OFF：
turn off master mode
TEST: testing mode
REST:
restore the
factory initial setup
ENTER to the testing mode
ENTER to restart the machine
NOTES：（1）S.01-S.99: program speed adjusting; S.01: the slowest, S.99: the fastest
2 A point will be shown on the screen if there’s no operation in 30s.
3 Machine address bit instruction, face to the LED screen, from left to right, the address
is 1-2-3-4.
4 The nixie tube will twinkle when there’s no signal input to SLAVE,D001.