Why is the room frost protection function activated on my Kampmann Katherm HK 290 Heater?
If the RGB sensor, AI1 sensor, or the virtual sensor in your Kampmann Heater measures a temperature of < 8°C, the fan is switched on at stage 1, and the heating valve is opened.
Why is the unit frost protection function activated on my Kampmann Katherm HK 290?
If the RGB sensor, AI1, AI2, AI3 sensor, or the virtual sensor measures a temperature of < 4°C, the fan is switched off, and the heating and cooling valve is opened.
What happens when motor protection is activated in Kampmann Katherm HK 290?
The fan is switched off and the cooling valve is closed.
Details limits for operation, environmental conditions, and water quality parameters.
Warns about fatal injury from electrocution and outlines safety precautions.
Guides on connecting condensate drains with natural gradient and using condensate pumps.
Lists electrical connection and rating values for different Katherm HK models and versions.
Explains the circuit, terminals, and wiring for 24V DC electromechanical units.
Explains the circuit, terminals, and wiring for 230V AC electromechanical units.
Safety procedures to prevent accidental restart during maintenance.
Lists common faults, their causes, and remedies for the unit.
Details KaControl alarms, fault codes, and restart procedures after repairs.
Details limits for operation, environmental conditions, and water quality parameters.
Warns about fatal injury from electrocution and outlines safety precautions.
Guides on connecting condensate drains with natural gradient and using condensate pumps.
Lists electrical connection and rating values for different Katherm HK models and versions.
Explains the circuit, terminals, and wiring for 24V DC electromechanical units.
Explains the circuit, terminals, and wiring for 230V AC electromechanical units.
Safety procedures to prevent accidental restart during maintenance.
Lists common faults, their causes, and remedies for the unit.
Details KaControl alarms, fault codes, and restart procedures after repairs.
General| Category | Heater |
|---|---|
| Width | 290 mm |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Heat output (EN 16430) | 2.9 kW |
| Heating capacity | According to selection |
| Length | According to selection |
To Next Page
