Kampmann Katherm HK - Assembly And Installation Instructions Manual

84 pages

Save Page as PDF

To Next Page

Katherm HK

Ready-to-install trench heaters for heating or

cooling with EC tangential fan

Assembly and installation instructions

Keep these instructions in a safe place for future use!

I517/07/19 EN | SAP No. 1237680

Main Page

Default Chapter2
- Table of Contents2
1 Intended Use4
- Description4
- Limits of Operation and Use5
2 Safety Information6
3 Designs/Scope of Delivery6
4 Alignment and Positioning7
- Alignment Using Height-Adjustment Feet and Raised Floor Brackets7
- Positioning and Fixing at the Installation Site7
5 Water Connections8
6 Screed Works8
7 Water Connection / Pipe Openings9
8 Katherm HK Optionally with Supply Air Function16
- Katherm HK with Supply Air Modules16
- Katherm HK - Supply Air Ducts ZL18
9 Condensation Drainage20
- General Information20
- Condensation Drainage with a Natural Gradient21
- Condensation Drainage Using the Condensation Pump Kit24
10 Number of Height-Adjustment Feet and Raised Floor Feet27
11 Maintenance28
- Information / Maintenance / Maintenance Intervals28
- Cleaning the Condensation Tray29
12 Consumption Figures30
13 Electrical Wiring31
- Overview of Controls32
- Electromechanical Electrical Model33
- Electromechanical Electrical Model35
14 Katherm HK, Kacontrol Model (*C1)39
- Intended Use39
- Function Keys, Display Elements40
- Operation41
- Activating and Deactivating the Control42
- Temperature Adjustment (Absolute Value)43
- Fan Setting44
- Time Setting45
- Timer Programs46
- Operating Modes (Mode Key)49
15 Alarm Messages50
- Alarm Messages from Kacontrol PCB, Display on Kacontroller50
- Kacontroller Alarm Messages50
16 Troubleshooting51
- A11 Control Sensor Faulty51
- A12 Motor Protection51
- A13 Room Frost Protection Function51
- A14 Condensation Alarm52
- A15 General Alarm52
- A16 Sensor AI1, AI2 or AI3 Faulty52
- A17 Unit Frost Protection Function52
- A18 EEPROM Error53
- A19 Slave Offline in the CAN Network53
- Problem Solution53
17 Kacontroller Installation54
18 Cabling55
- General Information55
- Terminal Resistors in a CAN-Bus System56
- Bus Connections between the Units56
- Kacontroller56
19 Setting Configuration of Unit by Means of DIP Switch57
20 Parameter Settings59
- General59
- Calling up the Service Menu59
- Heating/Cooling Changeover Via Clip-On Sensor in 2-Pipe Systems60
- Setting DIP Switch No. 3, DIP Switch No. 460
- Setting Automatic Heating/Cooling or Day/Eco Changeover Mode60
- Function of Digital Inputs DI1 and DI262
21 Functional Testing of Connected Assemblies67
- External Control Via 068
- Parameter List for Kacontrol PCB69
- Electrical Wiring73
  - Control by On-Site BMS73
  - Master Unit and Slave Units74
22 Declaration of Conformity76

Kampmann Katherm HK - Assembly And Installation Instructions Manual

Table of Contents

Other manuals for Kampmann Katherm HK

Related product manuals