EasyManua.ls Logo

K&S BASIC KSB 22i S - Engine Overheating and No Voltage; Connected Devices Not Working; WARRANTY SERVICE TERMS

K&S BASIC KSB 22i S
14 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WARRANTY SERVICE TERMS
18
The international manufacturer warranty is 1 year. The warranty period starts from the date of purchase. In cases when
warranty period is longer than 1 year according to local legislation please contact your local dealer. The Seller which sells
the product is responsible for granting the warranty. Please contact the Seller for warranty. Within the warranty period,
if the product fails because of defects in the production process, it will be exchanged on the same product or repaired.
All faults caused by the manufacturer during the warranty period will be eliminated free of charge. Warranty repair is
carried out only if you have a fully completed warranty card, the Buyer’s signature of acceptance of the warranty terms, as
well as a document supporting the purchase (cash receipt, sales slip or invoice). In the absence thereof, as well as in the
event of errors or corrections not authenticated by the seller’s seal or illegible inscriptions in the warranty card or tear-o
coupon, no warranty repair is carried out, no objections to quality are accepted and the warranty card is withdrawn by
the service center as invalid. The device is accepted for repair clean and full.
Typical failures Possible reason Solution
Engine overheated
Cooling ns are dirty Clean the cooling ns
Air lter is dirty Clean the air lter
No voltage while
working engine
Circuit breaker is active Turn on the cricuit breaker
Connected cables are corrupted
Check the cables; if using extension
cord, change it
Plugged device failure Try to connect other devices
Connected devices
are not working
while generator is
running
Generator is overloaded
Unplug some devices to
reduce load
Short circuit occured in one of
the devices connected
Unplug that device to restore
the stability of a system
Air lter is dirty Clean the air lter
Repetitions of an engine are
lower than nominal
Contact the service center
konner-sohnen.com | 11

Related product manuals