Need help?Do you have a question about the K&S BASIC KSB 22i S and is the answer not in the manual?
Do not use generator in poor ventilation, humidity, or near flammable liquids. Keep area clear.
Pay attention to appliance capacity, starting current, phase compatibility, and exhaust gas entry.
Follow safety for electric shock, use IT/TN systems, earthing, and protective measures.
Avoid feedback connections. Do not operate when tired or under influence.
Do not start with load, use unleaded fuel, define emergency stop, do not refuel while running.
Identifies key parts like fuel tank cap, carrying handles, control panel, and manual starter.
Ground generator before use. Ensure total power of consumers does not exceed nominal power.
Ensure control panel, blinds, and underside are cooled and protected from dirt and water.
Explains oil, AC, overload indicators and troubleshooting steps for overload conditions.
Describes the DC protector switching off due to overcurrent and reset procedures.
Instructions for checking and filling fuel and engine oil levels before operation.
Ensure power consumers match generator power. Do not connect devices before starting.
Warning against changing controller settings and ensuring power consumers match generator power.
Steps for initial setup including filling oil, checking fuel, and air filter.
Requirements for the first 20 hours, including load limits and oil change after break-in.
Step-by-step guide to starting the engine, including choke and manual starter usage.
Emphasizes checking oil, fuel levels, and connecting the ground wire before starting.
Explains ECON switch operation (ON/OFF modes) for fuel efficiency and load handling.
Details oil types, air filter cleaning, and fuel filter maintenance procedures.
Guidance on spark plug verification, gap measurement, and damper/flame arrester maintenance.
Guidelines for proper generator storage and environmentally sound disposal.
Troubleshooting common problems like engine not starting, low power, or heavy starting.
Addresses issues like engine overheating, dirty filters, and no voltage output.
Troubleshoots why connected devices might not be working, including overload and cable issues.
General| Brand | K&S BASIC |
|---|---|
| Model | KSB 22i S |
| Category | Portable Generator |
| Language | English |
To Next Page
