Assembly InstructionsKangaroo
11
Part 2: Lift Panel
3.5x14 Screw x4
Attach the Lift to Panel A2 using s1 Screws.
Guide Lift onto Lift Rails using plastic guides. Insert ends of cable into rail tabs; make sure the cable is hooked into the rail
tabs on both sides.
NOTE: See Page 10 for close-up illustrations of Lift Panel assembly.
Cut the zip tie on the wooden block, but DO NOT remove the block yet.
Lower the Lift to first lock position and remove the
wooden block. DO NOT ADJUST LIFT POSITION until the
top is installed, or you risk the Lift
coming out and cables becoming
disengaged.
To Next Page
Loading...
