COMMANDS
13
CONVers
immediate All Units Packet
CONVers has no options. It is an immediate command and will cause entry into Conversational
Mode from Command Mode on the current I/O stream. Any link connections are not affected.
See also: k, command
CPactime ON | OFF
default OFF All Units Packet
When OFF and in the Convers Mode, packets are sent when the SENDPAC character is entered or
when PACLEN is achieved. When ON and in the Convers Mode, packets are sent at periodic inter-
vals determined by PACTIME. Characters are sent periodically as in Transparent Mode but the local
editing and echoing features of Convers Mode are enabled. CR should normally be OFF in this con-
figuration, otherwise the SENDPAC character is appended at random intervals as the input is
packetized by the timer.
See also: convers, cr, paclen, pactime, sendpac, trans
CR ON | OFF
default ON All units Packet
When ON the SENDPAC character (normally carriage return) is appended to all packets sent in
Convers Mode. Setting CR ON and SENDPAC $0D results in a natural Conversation Mode. Each line
is sent when a <CR> is entered and arrives at its destination with the <CR> appended to the end
of the line. To avoid overprinting, AUTOLF may need to be ON at the receiving end.
See also: autolf, lfadd, sendpac
CRAdd ON | OFF
default OFF KAM RTTY/ASCII/AMTOR
When ON, a <CR> character is added to any <CR> character sent to the radio. This is to allow a
<CR><CR><LF> sequence.
CRLfsup ON | OFF NOT IN V 5.0
default OFF KAM RTTY/ASCII/AMTOR
When ON, extra <CR> and <LF> characters following a <CR> are not sent to the terminal.
See crsup and lfsup
CStamp ON | OFF
default OFF All Units Packet
When ON, the daytime stamp is printed with all ***connected to and ***disconnected
messages on the display.
See also: connect, daytime, disconnect, mstamp
To Next Page
Loading...
