COMMANDS
21
HELp
immediate All Units All Modes
Causes a display of all possible commands.
HF ON | OFF
default OFF
KPC-2/KPC-2400
Packet
This commands sets the TNC for operation on the High Frequency bands. With this command ON,
the modem output baud rate (HBAUD) is set to 300. The specific tones used are dependent on the
current setting of the CCITT and HFTONES commands. Analysis of the tone chart in the CCITT
command shows that with HF ON a selection of four different tone pairs are available based on the
CCITT and HFTONES command settings. Selection of any particular pairs is not critical, though you
may find that one will perform better than another under some band conditions.
See also: ccitt, hbaud, hftones
default OFF
KPC-1
This commands sets the TNC for operation on the High Frequency bands. With this command ON,
the modem output baud rate (HBAUD) is set to 300. The specific tones used are dependent on the
current setting of the HFTONES commands.
See also: hbaud, hftones
HFTones ON | OFF
default OFF
KPC-2/KPC-2400
Packet
This command, when used in conjunction with the CCITT and HF commands, selects the particular
tone pair to be used. Analysis of the tone chart in the CCITT command will give the combinations
possible.
See also: ccitt, hf
default OFF
KPC-1
Packet
This command, when used in conjunction with the HF command selects the particular tone pair to
be used.
HF HFTONE TONE PAIR
off
off
on
on
off
on
off
on
1200/2200 (Bell 202)
1200/2200 (Bell 202)
1070/1270 (Bell 103)
2025/2225 (Bell 103)
See also: hf
To Next Page
Loading...
