COMMANDS
26
MCOM ON | OFF
default OFF
KPC-1/KPC-2/KPC-2400
Packet
default OFF/OFF
KAM/KPC-4
Packet
When ON, monitored packets include the following AX.25 control packets, if MONITOR is ON. If
connected, MCON must also be ON. The "<" and "<<" characters are used to bracket and denote
packets received as version 1 or version 2, respectively. The bracketed information will appear at
the end of the header information.
<C> Connect request
<D> Disconnect request
<DM> Disconnect Mode
<UA> Unnumbered Acknowledge
In addition, the following bracketed information will be added to the Information packets as appro-
priate:
<UI> Unconnected Information frame
<Is> Information frame (connected); s = send sequence number
See also: ax25l2v2, monitor, mresp
MCon ON | OFF
default OFF
KPC-1/KPC-2/KPC-2400
Packet
default OFF/OFF
KAM/KPC-4
Packet
When OFF and connected, you will monitor only those packets addressed to you. Any header infor-
mation displayed will be determined by the settings of STREAMEV and STREAMCA. When OFF and
not connected, all eligible packets (as determined by other monitor commands) will be monitored.
When ON, all eligible packets will be monitored whether connected or unconnected.
See also: monitor, streamca, streamev
MHClear
immediate All Units Packet
This command erases the stations heard log.
See also: mheard
To Next Page
Loading...
