COMMANDS
31
MYNode xxxxxx-n V 2.8
default MYCALL All Units KA-NODE
This command tells the TNC what callsign is to used when a remote station is connecting to the
KA-NODE. Enter up six characters, using a callsign (plus an SSID) which is different than that used
for MYCALL, MYALSIAS, MYPBBS or MYGATE.
See also: digipeat, ndwild, unmnodes
MYPbbs xxxxxxx-n V 3.0
default MYCALL All Units PBBS
Enter up to six characters which will be used as the operating address for your Personal Packet
Mailbox. Enter up to six characters, using a callsign (plus an SSID) which is different than that
used for MYCALL, MYALIAS, MYNODE or MYGATE.
See also: ppbs
MYPTcall xxxxxxxx V 6.0
default mycall KAM PACTOR
Establishes callsign used for PACTOR link. Up to 8 characters/numbers may be entered.
MYRemote xxxxx V 5.0
default blank
?????
MYSel4 xxxx V 3.0 – NOT IN V 5.0
KAM AMTOR
The 4 character selcal specified by xxxx will be recognized, when operating in AMTOR Mode A, as
your station identification. The convention used for AMTOR selcals is to use the first letter and
then the last three letters of your callsign. If your callsign has only three letters, use the first letter
twice. For example use WWXI for W0XI or use DCXJ for DC7XJ. The MYSEL4 will also accept 4 or 5
digit numbers and generate the corresponding 4 character selcal automatically from these num-
bers. (See the AMTOR section in the Operating Manual.)
See also: amtor fec, mysel7, myselcall
To Next Page
Loading...
