COMMANDS
34
NDHeard [S | L] V 2.8
immediate All Units Packet
This command allows the operator to display a list of Nodes whose ID packet has been heard by
the TNC. The list includes KA-NODEs as well as TheNet and NET/ROM nodes. TheNet and
NET/ROM nodes are identified as:
ALIAS (CALLSIGN)
and Kantronics KA-NODEs will be identified as:
MYNODE (MYCALL)
An asterisk, *, indicates that the station was heard through a digipeater. The date/time the station
was last heard is also displayed. If the S option is used, i.e. NDHEARD S, then only callsigns of the
stations heard will be displayed. If the L option is selected, all callsigns contained in the received
packet are displayed. (See MHEARD for display.)
See also: mynode ndhclear
NDWild ON | OFF V 2.85
default OFF All Units KA-NODE
When OFF, the KA-NODE will only recognize connect request directed to the MYNODE call. When
ON, connect requests to any SSID of the MYNODE call will be recognized as connects to the KA-
NODE, if that SSID is not being used for any other ID in the TNC.
See also: myalias, mycall, mygate, mynode, mypbbs
NEwmode ON | OFF
default ON All Units Packet
When ON, the TNC will return to Command Mode if the station on the current I/O stream discon-
nects. The TNC will not return to Command Mode if the station disconnecting is on a different
stream. When OFF, a disconnect will not cause the TNC to change modes.
See also: connect, disconnect, status
NOmode ON | OFF V 2.3
default OFF All Units Packet
When OFF and a connection takes place, the TNC will change to whatever mode is specified in
CONMODE. When ON, the TNC stays in Command Mode after connecting to another station; that
is, it does not immediately change to Convers or Transparent Mode.
See also: conmode, connect
To Next Page
Loading...
