COMMANDS
42
REConnec call (VIA call2, call3 ... call9) NOT IN KAM V 5.0
immediate All Units Packet
This command may be used to change the path by which you are currently connected to another
station. It may only be used when you are connected on the current stream to the station you
wish to reconnect to, or while attempting to connect to a station.
– CAUTION –
Packets enroute between your station and the reconnected station may be lost at the time the re-
connected is executed.
See also: connect
REdisplay n (n = $00 – $FF)
default $12 (Ctrl-R) All Units All Modes except WEFAX
This command is used to change the REDISPLAY-packet input editing character. The parameter n
is the ASCII code for the character you want to type in order to REDISPLAY the packet currently
being entered.
You can type this character to cause the TNC to redisplay the packet you have begun. When you
type the REDISPLAY-packet character, the following things happen: First, type-in flow control is re-
leased (if FLOW was enabled). This displays any incoming packets that are pending. Then a \
(backslash) character is displayed and the packet you have begun is redisplayed on the next line.
If you have deleted and retyped any character, only the final form of the packet will be shown. You
are now ready to continue typing where you left off. Incoming packets will continue to be dis-
played until you type the next character to be inserted into the packet.
You can use the REDISPLAY-packet character to see a "clean" copy of your input if you are using a
printing terminal (or have BKONDEL OFF) and you have deleted characters. The REDISPLAY-packet
will show the corrected text.
You can also use this character if you are typing a message in Convers Mode and a packet comes
in. You can see the incoming message before you send your packet, without canceling your input.
In non-packet modes you can use this character to see what characters are still in your transmit
buffer.
See also: bkondel, canline, canpac, flow
RELink ON | OFF V 2.8
default OFF
KPC-1/KPC-2/KPC-2400
Packet
default OFF/OFF
KAM/KPC-4
Packet
When OFF, the TNC operating with AX25L2V2 ON does not attempt automatically reconnect. When
ON, the TNC operating with AX25L2V2 ON will attempt to automatically reconnect after RETRY is
exceeded.
The KA-NODE and the PBBS will never attempt to reconnect regardless of the setting of this com-
mand. If using AX.25 Level 2 Version 1 (AX25L2V2 OFF) this command has no effect.
See also: ax25l2v2, retry, tries
To Next Page
Loading...
