COMMANDS
47
STREAMEv ON | OFF
default OFF All Units Packet
When OFF, the stream indicator is displayed only when a change in streams occurs. When ON, the
stream indicator will be displayed with every incoming packet. This command takes effect when
monitoring only those packets addressed to you.
See also: mcon, monitor, streamca, streamsw
STReamsw n (n = $00 – $FF)
default $7C ( | )
KPC-1/KPC-2/KPC-2400
Packet
default $7E/$7C ( ~/| )
KAM
Packet
default $7C/$7E ( |/~ )
KPC-4
Packet
This command selects the character(s) to be used to signify that a new "stream" or connection
channel is being addressed. To change streams you must type streamswitch character followed im-
mediately by the stream designator. The stream designator is an alphabetic character A trough Z
limited by the value of MAXUSERS. If STREAMSW is set to a dollar sign ($24) you will need to en-
ter numerical code type parameter values in decimal. Or precede the $ with the PASS character in
order to enter hex numbers.
The character selected can be PASSed in the Convers Mode by using a special PASS character and
will always be passed as data in in the Transparent Mode. If operating in the Transparent Mode
and you wish to change streams, you must first return to the Command Mode.
See also: maxusers, pass, status
SUPCalls [+ | -]callsign or NONE
default NONE All Units Packet
A list up to 10 callsigns for use with SUPLIST or LLIST. To delete or add indvidual entries precede
the callsign with a - or + respectively. For example to delete WD0EMR type SUPC -WD0EMR.
See also: llist, suplist
SUplist OFF(NO, NONE) | TO | FROM | BOTH(ON, YES)
default OFF All Units Packet
When OFF, SUPLIST will allow monitoring of all eligible packets (according to other monitor com-
mands) even if the SUPCALLS list has callsigns in it. When BOTH or ON, packets addressed to or
from these stations whose calls are listed in the SUPCALLS will not be monitored. If SUPLIST is TO,
only those packets addressed to a station in the SUPCALLS list will not be monitored, those from
that station will be monitored. When set to FROM, those packets addressed from the stations in
SUPCALLS will not be monitored, but those packets addressed to the stations in the SUPCALLS list
will be monitored. Note that SUPLIST takes precedence over BUDLIST. For instance if you have
W0ABC in your SUPCALLS with SUPLIST TO and you have W0DEF in your BUDCALLS with BUD-
LIST BOTH, then packets from W0DEF to W0ABC will NOT be monitored.
See also: monitor, supcalls
To Next Page
Loading...
