COMMANDS
51
USers n (n = 0 – 26)
default 1
KPC-1/KPC-2/KPC-2400
Packet
default 1/1
KAM/KPC-4
Packet
This command specifies the channels (streams) which may be available to incoming connect re-
quests. For example, if USERS = 5 then an incoming connect request will connect to the lowest
channel A – E, if any of these channels are in the unconnected state. If none of the 5 channels are
available (all of them are connected), a <DM> packet will be sent back to the requesting station
and the message ***connect request: (call) will be output to your terminal, if permitted.
If USERS are set to 0 no one will be able to connect to you. If USERS is set higher than
MAXUSERS, the extra is ignored and the message USERS LIMITED BY MAXUSERS will displayed.
See also: intface, maxusers, streamsw
USOs ON | OFF
default ON KAM RTTY
When ON, an unshift to letters case is effected when a space is received in BAUDOT RTTY. If
LCRTTY is ON, a space will cause an unshift to lower case.
Version V 5.0
immediate KAM
Shows the software version.
Wefax n
immediate All Units WEFAX
This command permits the reception of Weather Facsimile. The audio input is sampled n times per
second, and a black/white decision is made on each sample. Each sample becomes one bit of the
data sent over the serial port to the computer. A special computer program must be used to dis-
play the WEFAX picture.
See also: daytweak; WEFAX Reception section of Operating Manual
WText message {up to 128 characters)
default (blank) KAM AMTOR
This entry specifies the text to be sent in response to a WRU command while in AMTOR (ARQ)
Mode only. Enter any combination of characters and spaces up to a maximum length of 128. Enter-
ing single % will clear WTEXT.
See also: Ctrl-W in the Directives section
To Next Page
Loading...
