DIRECTIVES
54
Ctrl-C D
KAM PACTOR
Disconnect the link. This sends the proper QRT packet to the other station and then enters the
PACTOR Standby Mode. Any pending data is discarded. This sequence may require some time de-
pending on link quality.
Ctrl-C E
KAM CW/RTTY/ASCII/AMTOR/PACTOR
Return to receive when transmit buffer empty.
Ctrl-C I
KAM RTTY/ASCII/AMTOR
Invert received signal (toggle inversion).
See also: invert in the Commands section
Ctrl-C L the xmit lock directive v2.84
KAM CW
Entering this combination during CW operation will cause the CW transmit speed to be set to the
receive speed at that moment. The directive also disables autotracking of received CW speed. See
Ctrl-C U to unlock receive speed and enable autotrack.
Ctrl-C R
KAM CW/RTTY/ASCII/AMTOR/PACTOR
Return to receive immediately – even if data remains in transmit buffer. In CW Mode this directive
also re-enables speed tracking.
Ctrl-C S
KAM RTTY/ASCII/AMTOR
Change shift to next standard. Standard shifts are 170, 425 and 850.
See also: shift in the Commands section
Ctrl-C T
KAM CW/RTTY/ASCII/AMTOR/PACTOR
Switch from receive to transmit or seize the ISS status in AMTOR.
Enter transmit mode from PACTOR Standby. This is useful for calling CQ or other broadcast trans-
missions. If you are linked to another station and currently receiving (IRS), this directive will also
allow you to seize the link (become the sending station – ISS) from the other station.
To Next Page
Loading...
