DIRECTIVES
58
Send callsign v2.7
All Units PBBS
This command is used to send a message to the PBBS. Following is an example with the informa-
tion you would type in red and the responses from the PBBS in blue.
>
s WK5M
SUBJECT:
short subject line
ENTER YOUR MESSAGE - END WITH CTRL-Z OR /EX ON A SINGLE LINE
Content of message is entered here
/EX
MESSAGE SAVED
ENTER COMMAND: B,J,K#,KM,L,LM,R #, RM, S, or Help
>
Nodes [S | L] v2.84
All Units KA-NODE
This command will cause the connected to KA-NODE to return a list of nodes heard, including KA-
NODEs, TheNet and NET/ROM nodes. If you are connected to a second KA-NODE trough an inter-
mediate KA-NODE, you will receive the nodes heard of the second KA-NODE. If the S option is
used, i.e. NODES S, then only the callsigns of the stations heard will be displayed. If the L option
is used, all callsigns contained in the received packet are displayed.
See also: ndheard in the Commands section
XConnect callsign v2.8
KAM/KPC-4 KA-NODE
This command will cause the KA-NODE to issue a connect request to 'callsign' in the AX.25 format
from the KA-NODE but uses the other radioport of the node. Cross-connecting enables you to gain
access via the node to another frequency.
To Next Page
Loading...
