Kärcher 1.575-615.0 - User Manual

42 pages

Save Page as PDF

To Next Page

9.800-103.0-M11/02/17

HDS 4.0/32 Pe Cage - 1.575-615.0

HDS 5.0/32 Pe Cage - 1.575-616.0

HDS 5.5/35 Pe Cage - 1.575-617.0

OPERATOR’S MAN U AL

To locate your local Kärcher Commercial Pressure Washer Dealer nearest you,

please visit www.karchercommercial.com

WARNING:

This product and accessories may contain a chemical known to the State of

California to cause cancer and birth defects or other reproductive harm.

For more information about this regulation: www.P65Warnings.ca.gov

Questions and Answers

A
Adrian GilmoreOct 31, 2025
Why is the Kärcher 1.575-615.0 Pressure Washer operating pressure low?
- R
  Ronnie CruzOct 31, 2025
  Low operating pressure in your Kärcher Pressure Washer can stem from several causes. Here's what you can check: * **Insufficient water supply:** Use a larger supply hose and clean the filter at the water inlet. * **Old, worn, or incorrect spray nozzle:** Match the nozzle number to your machine or replace it with a new one. * **Plumbing or hose leak:** Inspect your plumbing system for leaks and retape them using Teflon tape. * **Obstruction in spray nozzle:** Remove any obstructions. * **Pump sucking air:** Examine the water supply and check for potential air seepage. Additionally, it could be due to a faulty pressure gauge (install a new one), belt slippage (tighten or replace the belt, ensuring it's the correct one), a faulty or mis-adjusted unloader valve (adjust or install a...
J
Jerry SparksNov 15, 2025
What to do if the Kärcher 1.575-615.0 burner will not light?
- M
  Matthew LopezNov 15, 2025
  If the burner on your Kärcher Pressure Washer won't light, several factors could be at play: * **Little or no fuel:** Refill the fuel tank. * **Improper fuel or water in fuel:** Drain the tank and replenish with the correct fuel. * **Clogged fuel line:** Clean or replace the fuel line. * **Plugged fuel filter:** Replace the fuel filter as needed. * **Little or no fuel pressure from fuel pump:** Increase fuel pressure to the specified level, and consider replacing the fuel pump. Use a pressure gauge for testing. * **Disconnected or short in electrical wiring:** Ensure all wire contacts are clean and secure, with no breaks in the wiring. Other potential issues include mis-adjusted burner air bands (readjust for a clean burn) and a faulty burner transformer (test for proper arc ...