5.956-518 English
5
How to operate the vacuum cleaner
secure in place (turn catches anti-clockwise as
far as they will go).
Replacing the paper filter bag
(Order no. 6.904-143)
■ Switch OFF the cleaner.
■ Undo both catches (turn clockwise), and lift
motor housing off dirt box.
! Remove the paper filter bag from the dirt box
and seal it.
■ Fit a new paper filter bag.
■ Place the motor housing on the dirt box, and
secure in place (turn catches anti-clockwise as
far as they will go).
Cleaning the flat folding filter
Every now and then (depending upon amount of
dirt):
■ Switch OFF the cleaner.
■ Press button and open filter compartment.
■ Lift out the flat folding filter and knock of any
dust, or
■ if the dirt can not be easily removed, clean the
filter under running water, and leave to dry,
or
■ if the dirt is particularly stubborn, replace the
filter.
Checking/replacing the flat folding filter
(Order no. 6.414-498)
Check the flat folding filter regularly for damage. If
any has occurred, you should replace the filter
immediately, otherwise the motor could also be
damaged.
■ Switch OFF the cleaner.
■ Press button, and open filter compartment.
■ Replace flat folding filter, and close cover to
filter compartment.
Checking and cleaning the accessories
■ Check the nozzle, suction hose or extension
tubes for blockages, and rinse out with water if
required.
At the start of your work
■ Check that the paper filter bag and the dirt box
are not full.
■ Insert the mains plug into a 230 V socket.
■ Press the ON/OFF switch.
When work has finished
■ Press the ON/OFF switch.
■ Unplug cleaner from the mains electricity.
■ Replace the paper filter bag or empty the dirt
box, if required.
Examples of how to use the cleaner
Dry-vacuuming
Fine, dry dirt is best vacuumed with the paper
filter bag fitted.
Note: Damage could be caused to the paper filter bag
if any coarse or sharp objects are picked up by the
cleaner.
Coarse, dry dirt can be vacuumed without a paper
filter bag.
Wet-vacuuming
Always operate the cleaner with the paper filter
bag removed.
■ Empty dirt box so that no sludge is formed
during cleaning.
When the dirt box is full, the cleaner switches off
automatically.
■ Press the ON/OFF switch, and empty dirt box.
These jobs must be carried out
regularly
Emptying the dirt box
■ With solids: no later than when the box is full.
■ With liquids: no later than when the cleaner cuts
out.
Note: After the cleaner has cut out, please set the
ON/OFF switch to “0”, otherwise the motor will start
up again when the cleaner is opened.
■ Undo both catches (turn clockwise), and lift
motor housing off dirt box.
■ Empty dirt box, rinse out if required, and dry the
inside.
! Place the motor housing on the dirt box, and
To Next Page
Loading...
