8
SHUTTING DOWN & CLEAN-UP
TAKING A BREAK... five minutes or more
Step 1
Remove detergent
suction tube from jug
and insert into 1 gallon
(5 L) of fresh water.
Siphon water at low
pressure for one minute.
Step 2
Turn the switch to
off (OFF) position
and unplug cord
from outlet.
Step 3
Turn off the water
source.
Step 4
Press trigger to
release water
pressure.
Step 6
Disconnect the high pressure hose from the high
pressure outlet and engage the gun safety lock.
Step 5
Disconnect the garden hose
from the water inlet on the unit.
Step 1
Engage gun
safety lock.
Step 2
Turn pressure
washer to off
(OFF) position.
1.Disconnect all water connections.
2.Turn on the machine for a few seconds,
until the water which had remained in
the pump exits. Turn off immediately.
3.Do not allow high pressure hose to
become kinked.
WINTERIZING AND LONG-TERM STORAGE
4.Store the machine and accessories in
a room which does not reach freezing
temperatures. DO NOT store near
furnance or other sources of heat as it
may dry out the pump seals.
Caution: Failure to follow the above
directions will result in damage to the
pump assembly and accessories.
To Next Page
Loading...
