To Next PageTo Next Page
Need help?Do you have a question about the Kärcher HDS 9/14-4 ST Eco and is the answer not in the manual?
General| Brand | Kärcher |
|---|---|
| Model | HDS 9/14-4 ST Eco |
| Category | Pressure Washer |
| Language | English |
Describes locations where the machine operates or accessories are connected.
Recommends protective equipment like ear plugs and goggles for safe operation.
Outlines the intended use of the machine for cleaning surfaces.
Explains how water, detergent, and heating systems work within the machine.
Details essential safety features like water shortage mechanisms and pressure switches.
Illustrates and labels the main physical parts of the machine.
Shows and explains the controls and indicators on the machine's control panel.
Step-by-step instructions for preparing the machine for operation.
Operator must use appliance correctly and pay attention to others.
Check hoses, connections, and water jet for damage before use.
Turn switch to "0", shut off water, activate gun until pressure-less.
Adjust quantity regulation valve for desired pressure and flow.
Instructions for setting up the optional Easy press gun.
Procedure for operating the machine with cold water supply.
Guidance for operating the machine with hot water.
Instructions for operating the machine in steam mode.
Details on how detergents are sucked in and their dosage settings.
Turn switch to "0", shut off water, release gun pressure.
Drain water, flush with anti-freeze, switch off main switch.
Advice on storing the appliance safely, noting its weight.
Cautionary notes for transporting the machine, securing it properly.
Daily, weekly, monthly, and annual checks for safe operation.
Checks for decalcification based on operating pressure increase.
Annual inspection as per national rules for liquid spray jets.
Periodic pressure testing as per manufacturer's instructions.
Information on entering a maintenance contract with Kärcher.
Instructions for cleaning the water inlet sieve and safeguard sieve.
Details on setting the ignition electrodes for optimal performance.
Steps for removing mineral deposits using cleaning agents.
Guidance on protecting the machine from frost damage.
Empty pump and conduits, drain heating spiral.
Fill tank with anti-freeze and run until safety mechanism activates.
Diagnosing why the machine won't start or the standby lamp is off.
Troubleshooting for the engine over-heating indicator lamp.
Problems related to the burner ignition and flame stability.
Troubleshooting for the burner failure indicator lamp.
Issues related to the burner failure indicator blinking.
Troubleshooting for the calcification protection indicator lamp.
Problems with detergent suction and metering.
Issues preventing the appliance from reaching full pressure.
Diagnosing knocking or wild manometer readings in the pump.
Troubleshooting for intermittent device operation.
Issues where the appliance fails to turn off when the gun is closed.
Selection of detergents for various applications and their pH values.
Follow local regulations, use certified chimneys/exhaust pipes.
Check wall load-bearing capacity and use appropriate fasteners.
Follow national laws for electrical appliances, check pressure loss.
Install tanks so lower mirror is not more than 1.5m under machine floor.
Connect water inlet to supply, check minimum output and temperature.
Follow technical data, hire electrician, protect parts from water.
Establishing the electrical connection with a main switch.
Steps to perform before the first use of the machine.
Essential checks to perform before starting hot water operations.
Steps to prevent calcium deposits in the continuous heater.
Setting the machine's automatic shutdown time during idle periods.
Declares compliance with EU basic safety and health requirements.
Outlines warranty conditions and repair provisions applicable in each country.
