4 English
petrol, paint thinner and heating oil. The
spray mist thus generated is highly inflamma-
ble, explosive and poisonous. Do not use ac-
etone, undiluted acids and solvents as they
are damaging to the materials from which the
appliance is made.
몇 Warning
The mains plug and the coupling of an exten-
sion cable must be watertight and must never
lay in the water.
Unsuitable extension cables can be hazard-
ous. Only use extension cables outdoors
which have been approved for this purpose
and labelled with a sufficient cable cross-sec-
tion: 1 - 10 m: 1.5 mm
2
; 10 - 30 m: 2.5 mm
2
Always fully unroll electrical cables from the
cable drum.
High-pressure hoses, fixtures and couplings
are important for the safety of the appliance.
Only use high-pressure hoses, fixtures and
couplings recommended by the manufacturer.
This appliance is not intended for use by per-
sons with reduced physical, sensory or men-
tal capabilities.
The appliance must not be operated by chil-
dren or persons who have not been instruct-
ed accordingly.
Children should be supervised to prevent
them from playing with the appliance.
The operator must use the appliance correct-
ly. When working with the appliance, he must
consider the local conditions and pay due
care and attention to other persons, in partic-
ular children, who are nearby.
Do not use the appliance when there are oth-
er persons around unless they are also wear-
ing safety equipment.
Wear protective clothing and safety goggles
to protect against splash back containing wa-
ter or dirt.
Caution
Do not operate the appliance at tempera-
tures below 0 °C.
In case of extended downtimes, switch the
appliance off at the main switch / appliance
switch or remove the mains plug.
Observe a distance of at least 30 cm when
using the jet to clean painted surfaces to
avoid damaging paintwork.
Never leave the appliance unattended when
it is in operation.
Make sure that the power cable or extension
cables are not damaged by running over,
pinching, dragging or similar. Protect the
power cable from heat, oil, and sharp edges.
All current-conducting parts in the working
area must be protected against jet water.
The appliance may only be connected to an
electrical supply which has been installed in
accordance with IEC 60364.
The appliance may only be connected to al-
ternating current. The voltage must corre-
spond with the type plate on the appliance.
For safety reasons, we recommend that you
operate the appliance only via a earth-leak-
age circuit breaker (max. 30 mA).
Cleaning operations which produce oily
waste water, e.g. engine washes, underbody
washes, may only be carried out using wash-
ing stations equipped with an oil separator.
This appliance was designed to be used with
detergents which are supplied or recom-
mended by the manufacturer. The use of oth-
er detergents or chemicals may compromise
the safety of the appliance.
Caution
Safety devices protect the user and must not be
modified or bypassed.
The appliance switch prevents unintentional op-
eration of the appliance.
This lock locks the lever of the trigger gun and
prevents the inadvertent start of the appliance.
Attach the wheel caps.
If the lever on the trigger gun is released the pres-
sure switch turns off the pump, the high-pressure
jet ist stopped. If the lever is pulled the pump is
turned on again.
Illustrations on Page 2
Mount loose parts delivered with appliance prior
to start-up.
Illustration
Î Pull out the clamp for the high-pressure hose
from the trigger gun (e.g. a small screwdriver).
Illustration
Î Connect high pressure hose to trigger gun.
Î Push the clamp in until it locks. Check the se-
cure connection by pulling on the high-pres-
sure hose.
Safety Devices
Power switch
Lock trigger gun
Overflow valve with pressure switch
Operation
Before Startup
To Next Page
Loading...
Need help?
General
