Kärcher K 2 BASIC Operating Instructions

English 9
 Release the lever on the trigger gun.
 Lock the lever on the trigger gun.
 Insert the trigger gun in its holder.
 During longer breaks (more than 5 minutes), also
turn the appliance off using the "0/OFF" switch.
몇 CAUTION
Only separate the high-pressure hose from the trigger
gun or the appliance while there is no pressure in the
system.
 After operation with detergent: Run the machine for
approximately 1 minute for a clear rinse.
 Release the lever on the trigger gun.
 Turn off the appliance "0/OFF".
 Disconnect the mains plug from the socket.
 Turn off tap.
 Press the lever on the trigger gun to release any re-
maining pressure in the system.
 Lock the lever on the trigger gun.
 Detach the appliance from the water supply.
몇 CAUTION
Risk of personal injury or damage!
Mind the weight of the appliance during transport.
 Lift appliance by the carrying handle and carry it.
 Secure the appliance against shifting and tipping
over.
몇 CAUTION
Risk of personal injury or damage!
Consider the weight of the appliance when storing it.
 Park the machine on an even surface.
 Engage the spray lance in its compartment.
 Insert the trigger gun in its holder.
 Stow away the mains cable, the high-pressure
hose and accessory on the appliance.
The high pressure hose is specially constructed with re-
inforced walls to handle water pressure up to 11 MPa
(1600 psi) - it can be easily damaged and should be
stored carefully.
 Do not kink.
 Do not drive vehicles over the hose.
 Do not expose the hose to sharp edges or corners.
Misuse will lead to ballooning or premature failure and
will invalidate warranty.
ATTENTION
Appliances and accessories that are not completely
drained can be destroyed by frost. Completely drain ap-
pliance and accessories and protect them against frost.
To avoid damage:
 Completely drain all water from the appliance:
Switch the appliance on with detached high pres-
sure hose and detached water supply (max. 1 min-
ute) and wait, until no more water exits at the high
pressure connection. Turn off the appliance.
 Store the appliance and the entire accessories in a
frost free room.
Prior to extended storage periods, as during the winter,
also observe the instructions in the Care section.
 DANGER
Risk of electric shock.
Prior to all work on the appliance, switch off the appli-
ance and pull the power plug.
Clean the sieve in the water connection regularly.
ATTENTION
The sieve must not be damaged.
 Remove coupling from the water connection.
Illustration
 Pull the sieve out using flat pliers.
 Clean the sieve under running water.
 Reinsert the sieve into the water connection.
 Remove filter from suction hose for detergent and
clean under running water.
The appliance is maintenance free.
Interrupting operation
Finish operation
Transport
When transporting by hand
When transporting in vehicles
Storage
Storing the Appliance
High pressure hose
Frost protection
Care and maintenance
Care
Clean the sieve in the water connection
Cleaning the detergent filter
Maintenance

Kärcher K 2 BASIC Specifications

General

Form factor	Compact
Hose length	3 m
Power source	Electric
Water filter	Yes
Castor wheels	No
Product color	Black, Yellow
Maximum flow rate	360 l/h
Working pressure (max)	110 bar
Maximum input water temperature	40 °C
AC input voltage	220-240 V
AC input frequency	50 - 60 Hz
Power consumption (typical)	1400 W
Surface cleaner	-

Weight and Dimensions

Depth	280 mm
Width	176 mm
Height	443 mm
Weight	4000 g