Kärcher K 5.530 - Maintenance and Troubleshooting; Care and Maintenance; Appliance Not Running; Pressure Build-up Issues

– 9
 Park the machine on an even surface.
 Press the disconnect on the trigger gun
and remove the high pressure hose
from the trigger gun.
 Push the casing of the quick coupling
for the high pressure hose toward the
rear and disconnect the high pressure
hose from the appliance.
 Stow away the mains cable, the high-
pressure hose and accessory on the
appliance.
Prior to extended storage periods, as dur-
ing the winter, also observe the instructions
in the Care section.
Caution
Protect the appliance and its accessories
against frost.
The appliance and its accessories can get
destroyed through frost if there are any wa-
ter residues in them. To avoid damage to
them:
 Completely drain all water from the ap-
pliance: Switch the appliance on with
detached high pressure hose and de-
tached water supply (max. 1 minute)
and wait, until no more water exits at the
high pressure connection. Turn off the
appliance.
 Store the appliance and the entire ac-
cessories in a frost free room.
 Danger
Turn off the appliance and remove the
mains plug prior to any care and mainte-
nance work.
Prior to longer periods of storage, e.g. in
the winter:
 Remove filter from suction hose for de-
tergent and clean under running water.
 Pull out the sieve in the water connec-
tion using flat-nose pliers and clean un-
der running water.
The appliance is maintenance free.
Use only original KÄRCHER spare parts.
You will find a list of spare parts at the end
of these operating instructions.
You can rectify minor faults yourself with
the help of the following overview.
If in doubt, please consult the authorized
customer service.
 Danger
Turn off the appliance and remove the
mains plug prior to any care and mainte-
nance work.
Repair works may only be performed by the
authorized customer service.
 Pull on the lever of the trigger gun; the
device will switch on.
 Check whether the voltage indicated on
the type plate corresponds to the volt-
age of the mains supply.
 Check the mains connection cable for
damages.
 Check setting at the spray lance.
 Appliance ventilation: Switch the appli-
ance on with the high-pressure hose
detached and operate (max. 2 minutes)
until the water exits the high-pressure
connection without bubbles. Switch off
appliance and reconnect high-pressure
hose.
 Check the water supply.
 Pull out the sieve in the water connec-
tion using flat-nose pliers and clean un-
der running water.
Storing the Appliance
Frost protection
Maintenance and care
Care
Maintenance
Spare parts
Troubleshooting
Appliance is not running
Pressure does not build up in the
appliance
19EN