English 7
STEP 5:
Insert detergent suction tube onto
the hose fitting.
Install the dosage regulator and
connect using 2 screws.
Note: During installation you must
make sure that the tongues of the
dosage regulator match up with the
intended recesses in the casing.
STEP 6:
Slide the free end of the coiled high
pressure hose through the recess-
es on the dosage regulator.
Insert the hose drum into the in-
takes on the transport handle.
Insert the axle of the hand crank
into the guides.
Rotate and press until the crank
locks in.
Install the holder bracket and se-
cure it using 2 screws.
Install the dosage regulator for detergent
Install the high pressure hose drum
To Next Page
