- 10
Î Remove the filter inlay and check it.
Î Use either a new or cleaned filter car-
tridge in the vacuum container.
Î Screw on wing nut.
Note
The machine has two hydraulic circuits:
Circuit sweeping hydraulics
Î Check the hydraulic oil level on the stor-
age container.
The oil level must lie between “MIN“
and “MAX“ marking.
Î If the oil level is too low, fill in hydraulic
oil above the fill neck on the top of the
container.
Circuit axle drive
Caution
This inspection may only be carried out
when the engine is cold.
Î Check oil level in the equalisation con-
tainer.
Î If required, top up oil carefully.
Check hydraulic oil level and refill hy-
draulic oil
Accessories
Side brushes 6.905-986.0
With standard bristles for indoor and out-
door areas.
Side-brushes, soft 6.906-133.0
For fine dust on inside surfaces; wetness
resistant.
Hard side-brushes 6.906-065.0
For removing stubborn dirt in the external
area; resistant to moisture.
Standard sweep roller 6.906-375.0
Resistant of wear and moisture. Universal
bristles for inside and outside cleaning.
Roller-brush, soft 6.906-533.0
With natural bristles especially for fine
dust sweeping on smooth indoor floors.
Not resistant to wetness; not for abrasive
surfaces.
Roller-brush, hard 6.906-532.0
For removing stubborn dirt in the external
area; resistant to moisture.
Dust filter 6.414-532.0
25EN
To Next Page
Loading...
Need help?
General