Kärcher OC 3 Plus - Troubleshooting Guide

English 11
2. Remove the valve opener using suit-
able pliers.
3. Remove the fine filter using suitable
pliers.
4. Clean the valve opener and the fine
filter under running water.
5. Insert the fine filter and th
e valve
ope
ner into the device.
ATTENTION
The pins on the fine filter and valve
opener must point upwards.
6. Place the water reservoir onto th
e
device.
Troubleshooting guide
 DANGER
Contact with live parts
Injury due to electric shock
Before carrying out any work on the
device, switch it off and disconnect it
from the charger.
Have repair work and work on electri-
cal components carried out only by au-
thorized Customer Service personnel.
Malfunctions often have simple causes
that you can remedy yourself using the
following overview. When in doubt, or
in the case of malfunctions not men-
tioned here, please contact your autho-
rized Customer Service.
Error Cause Rectification
The device does
not run
The charging state of the
battery is too low.
1. Check the charging stat
e of
th
e battery, charge the battery
if necessary.
The motor is overloaded, the
motor circuit breaker has
tripped.
1. Switch off the device.
2. Allow the device to cool down.
3. Switch on the device and pu
t
it into op
eration.
The ambient temperature is
outside the permissible
range (see chapter Techni-
cal data) and the motor cir-
cuit breaker has tripped.
1. Switch off the device.
2. Allow the device to cool down
or heat up.
3. Switch on the device and pu
t
it into op
eration.
If the malfunction occurs sev-
eral times, contact the autho-
rized Customer Service.