Kärcher ProNT 200 - Care and Maintenance; Storage; Transport; Troubleshooting

– 4
몇 CAUTION
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
 Remove the suction pipe with the floor
nozzle from the holder. Hold the appli-
ance at the handle and at the suction
pipe to transport it.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
몇 CAUTION
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.
 DANGER
First pull out the plug from the mains before
carrying out any tasks on the machine.
 Main filter basket (washable), clean it
under running water if necessary.
ATTENTION
Risk of damage! Never insert the main filter
basket while wet.
 Release and remove the suction head.
 Turn the suction basket by 180° and
keep it aside.
 Loosen the filter cover locks.
 Open filter door.
 Replace the flat pleated filter.
 Close the filter cover.
 Lock in the filter cover locks.
 Insert and lock the suction head.
 Release and remove the suction head.
 Clean the electrodes with a brush.
 Insert and lock the suction head.
 DANGER
First pull out the plug from the mains before
carrying out any tasks on the machine.
 Check the receptacle and the fuse of
the power supply.
 Check the power cable, the power plug,
the electrodes and possibly the recep-
tacle of the device.
 Turn on the appliance.
 Empty the container.
 Turn off the appliance and wait for 5 sec-
onds, turn it on again after 5 seconds.
 Clean the electrodes as well as the
space between the electrodes with a
brush.
 Remove blockages in the suction noz-
zle, suction tube, suction hose, or flat
pleated filter.
 Replace fleece filter bag.
 Clean the main filter basket (special ac-
cessory) under running water.
 Press the semi-automatic filter dedust-
ing key five times with the appliance
switched on.
 Ensure the filter cover properly locks
into place.
 Clean or replace the membrane filter
(special accessory) under running wa-
ter.
 Replace the flat pleated filter.
 Check/correct the correct positioning of
the flat pleated filter.
 Replace the flat pleated filter.
 Insert undamaged main filter basket
(special accessory).
Transport
Storage
Care and maintenance
Clean main filter basket (special
accessory)
Exchanging the flat pleated filter
Cleaning the electrodes
Troubleshooting
Suction turbine does not run
Suction turbine turns off
Suction turbine does not start again
after the container has been
emptied
Suction capacity decreases
Dust comes out while vacuuming
14 EN