EasyManua.ls Logo

Kärcher SC 1202 - Squeegee Usage; Floor Nozzle Usage

Kärcher SC 1202
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
24 English
You can use the steam gun without any ad-
ditional accessories.
Application:
elimination of odours and creases from
garments: Apply steam to the hanging
garment from a distance of 10–20 cm.
Removing dust from plants: Respect a
distance of 20-40 cm.
dusting with a damp cloth: Apply a small
amount of steam to a cloth, and then use
this cloth to wipe over the furniture.
The closer you hold the nozzle to the dirty
spot, the higher the cleaning effect as tem-
perature and pressure of the steam reach
their maximum values immediately when
they are emitted from the nozzle.
Application:
Fittings, drains
Wash-basins, toilets
Blinds, radiators
Stain removal: Moisten stubborn lime-
stone with vinegar, and allow to react for
approximately 5 minutes.
Note: The round brush is not suited for the
cleaning of delicate surfaces.
The extension piece is attached to the detail
nozzle.
Application:
locations that are difficult to access, such
as corners and joints
Fittings, drains
Pull the terry cloth cover (E2) over the man-
ual nozzle.
Application:
small, washable surfaces, such as kitch-
en surfaces made of plastic, tiled walls
Shower cabins, mirror
Furniture fabrics
Vehicle interior, windshields
Bath-tubs
Application:
Windows, mirrors
Glass surfaces on showers
other smooth surfaces
Î Perform a fat dissolving basic cleaning
using the manual nozzle and a terry cloth
cover before the first cleaning using the
window nozzle.
Î Apply steam to the glass surface from a
distance of approximately 20 cm until the
surface is moistened evenly.
Î Strip the glass surface in straight lines
from the top to the bottom using the rub-
ber lip of the window nozzle. Wipe the
rubber lip and the bottom edge of the
window dry after each strip.
Application:
all washable wall and floor coverings,
e.g.: Stone floors, tiles, and PVC floors.
Î Attach the floor cloth to the floor nozzle.
1 Fold the floor cloth the long way and
place the floor nozzle on top of it.
2 Open holding clamps.
3 Place the cloth ends into the openings.
4 Close the holding clamps.
Caution
Do not insert fingers between the clamps.
Figure 9
Î To remove the cloth, press the retaining
clips (H2), and pull out the cloth.
Î Turn and exchange the floorcloth in reg-
ular intervals. Thus, you improve the
ability to pick up dirt.
Î Work slowly on very dirty surfaces to al-
low the steam to act on the dirt for a long-
er period of time.
Steam gun (C1)
Detail nozzle (D1)
Round brush (D2)
Manual nozzle (E1)
Squeegee
Floor nozzle (H1)

Table of Contents

Related product manuals