Kärcher SC 2 EasyFix Manual

– 9
 Illustrations on fold-out
page!
Illustration
 Insert steering roller and transport
wheels and lock them.
Illustration
+
 Connect the required accessories (see
Chapter "How to use the accessories“)
to the steam gun. Insert the open end of
the accessory on the steam gun and
push onto the steam gun until the un-
locking button of the steam gun locks
into place.
Illustration
 Use the extension tubes if necessary.
To do so, connect one or both exten-
sion tubes to the steam gun. Insert the
required accessories on the free end of
the extension tube.
 Move the selector switch for the steam
volume back (steam lever locked).
Illustration
 To detach the accessory parts, press
the unlocking button and pull the items
apart.
Notes
 In case of continuous use of commer-
cially available distilled water, no des-
caling of the boiler is necessary.
 You can reduce the heating-up time by
using warm water.
 Remove the safety lock from the de-
vice.
Illustration
 Completely empty the steam boiler to
remove existing water.
 Fill the boiler with a maximum of 1 liters
of fresh tap water.
 Screw the safety cap back onto the de-
vice.
 Place the unit securely on a firm sur-
face.
 Insert the mains plug into a socket.
 Press the ON switch to turn on the ap-
pliance.
Both indicator lamps must illuminate.
 The orange indicator lamp goes out af-
ter approximately 8 minutes.
The steam cleaner is ready to use.
Use the selector switch for the steam vol-
ume to regulate the discharged steam. The
selector switch has three positions:
C1 Detail nozzle
C2 Round brush Black
C3** Power noz-
zle
C4** Round brush Large
D1 Hand nozzle
D2 Manual nozzle microfibre cover
E1 Extension tubes (two tubes)
E2 Unlocking button
F1 Floor nozzle
F2 Hook and loop
fastener
F3 Microfibre floor
cloth
F4** Microfibre floor
cloth 2 pieces
** Optional
Operation
Attaching the Accessories
Removing the Accessories
Fill up with water
Turning on the Appliance
Adjusting the Steam Quantity
Maximum steam volume
Reduced steam volume
No steam - child protection
Note:
In this lever position, the steam lever
cannot be used.
19EN

Kärcher SC 2 EasyFix Specifications

General

Type	Cylinder steam cleaner
Capacity	1 L
Cord length	4 m
Hose length	2 m
Product color	Black, Yellow
International Protection (IP) code	IP4X
AC input voltage	220 - 240 V
AC input frequency	50 - 60 Hz
Ready time	6.5 min
Steam pressure	3.2 bar
Child lock	Yes

Weight and Dimensions

Depth	380 mm
Width	254 mm
Height	260 mm
Weight	2900 g