Kärcher WV 60 plus - Page 5

English 5
Illustration
 Place the attachment on the suction
head with the removable lips until you
hear it lock in.
Note: Depending on the size and ac-
cessibility of the surface to be cleaned,
use the corresponding attachment
(wide or or narrow).
Note: Please note that after first activation
of the spray head the transport look will be
loosen.
Illustration
 Remove the spray head from the spray
bottle.
 Attach the wiper attachment to the
spray head.
 Secure the wiper attachment and the
spray head with the fixating ring.
Illustration
 Attach the wiper pad to the wiper at-
tachment and secure with Velcro.
Illustration
 Fill the included concentrate (1 x 20 ml)
into the spray bottle and fill the bottle
slowly with clear water (makes 250 ml
of detergent solution).
 Close the bottle.
Illustration
 Insert the charger delivered with the ap-
pliance into a proper socket.
 Insert the charging cable plug to the
back of the appliance.
Note: During the charging process, the
charge/operating display blinks. Once
the battery is fully charged, it will be per-
manently illuminated.
Recharge the battery after finishing
your work.
Illustration
 Press the spray lever on the bottle to
apply the detergent and spray the sur-
face evenly; after that, loosen the dirt
using the wiping pad.
Note: Rinse pad under running water if
needed!
Illustration
 Switch the appliance on, the charge/op-
erations display will illuminate.
 Pull the appliance from the top to the
bottom to vacuum up the detergent.
Note: Hard to reach areas can be vacu-
umed vertically or horizontally (limited
areas).
Notes:
If the battery is losing its performance, the
charge/operations display will begin to blink
slowly and the appliance will shut off after a
certain time. In this case, recharge the bat-
tery.
Switch the appliance off after each cleaned
surface. This will increase your operating
time per battery charge.
 Apply the detergent as usual according
to manufacturer's instructions and loos-
en the dirt.
 Further procedure same as the "Clean-
ing with spray bottle and wiper attach-
ment", see illustration .
Illustration
 Set the appliance on the support leg
(parking position) and switch it off.
Assemble the appliance
Attach the spray bottle and wiper at-
tachment and fill it with detergent
Attach the wiping attachment
Fill the spray bottle
Charge the battery
Start working
Cleaning with spray bottle and wiper at-
tachment
Cleaning without the spray bottle
Interrupting the work