To Next PageTo Next Page
Need help?Do you have a question about the Karl Storz UNIDRIVE S III 20701020-1 and is the answer not in the manual?
General| Brand | Karl Storz |
|---|---|
| Model | UNIDRIVE S III 20701020-1 |
| Category | Medical Equipment |
| Language | English |
Explains the meaning of Warning, Caution, and Note symbols and their importance.
Emphasizes observing manuals for combined devices and system compatibility.
Details operational limits, voltage, fuses, accessories, and liquid protection for the UNIDRIVE S III.
Covers critical safety measures like electrical installation and unit placement.
Covers grounding, pre-use checks, use with anesthetics, maintenance, and service.
Details safety procedures for morcellator use, cleaning, cutter replacement, and disposal.
Highlights safety warnings regarding accessory use and operational restrictions.
Details user responsibility for system safety, patient care during operation, and EMC compliance.
Guides on unit placement, ground line connection, voltage, and power cord safety.
Covers electrical safety in medical rooms and compliance of connected equipment.
Details the procedure for powering on the UNIDRIVE S III and the initial startup sequence.
Details how to set the operating mode and maximum speed for the Morcellator.
Explains how to enter and use the service mode to retrieve device data.
Provides detailed explanations and solutions for various error codes displayed by the device.
Details the procedure for safely inserting the morcellator, including warnings and recommendations.
Details cutter installation, locking, and important safety warnings for reusable and disposable cutters.
Provides a detailed guide on how to safely replace the unit's fuse.
Details the process of removing the cutter and sealing cap from the morcellator handle, including safety warnings.
Details cleaning, disinfection, and sterilization methods for instruments and the device, including safety notes.
Provides detailed instructions for manual cleaning and disinfection of the hollow shaft motor.
Details machine cleaning and disinfection for the motor and components, including tray holder recommendations.
Covers general sterilization requirements and warnings, including preparation and autoclaving.
Explains the procedure and parameters for steam sterilization of components.
Lists specific error codes, their causes, and recommended remedies for troubleshooting.
Guides on troubleshooting common device failures, error codes, and their solutions.
Addresses common problems with the morcellator, such as cutter insertion and gas leakage.
