KARLSON WRCE100RF - Care & Maintenance

34
Care & Maintenance
LOOKING AFTER YOUR APPLIANCE
WARNING: Increase the lter cleaning/replacement frequency if
the hood is used for more than 2 hours a day. Always use genuine
lters from the manufacturer.
25
EN Care & maintenance FR Entretien et maintenance
PL Czyszczenie i konserwacja RO Îngrijire și întreținere
EN
Care & maintenance
01 Carbon filter replacement
Replace every three months.
CARBFILT4
3 MONTHS
2 x Carbon filter, model number CARBFILT4
3663602843092 available via the customer
helpline - see end of Care & maintenance
section for details.
If the motor is off, and after the fan has been in operation for approximately 150 hours, the display will show
and the Timer will flash red to advise you to replace the carbon filters. After replacing the filters, reset the alert by
pressing the Timer icon.
WARNING: Always switch off the electrical supply before carrying out maintenance work on the hood. In the
event of a fault, contact customer services.
02 Aluminum grease filter cleaning
Aluminium filters: To avoid fires, clean thoroughly once a month. Remove both grease filters as shown and soak in
hot water and detergent for an hour. If using a dishwasher position the filters vertically to improve the cleaning
process.
1 MONTHS
65 C
If the motor is off, and after the fan has been in operation for approximately 50 hours, the display will show
and the Timer will flash red to advise you to clean the aluminum grease filters. After cleaning the filters, reset the alert
by pressing the Timer icon.
WARNING: Increase the filter cleaning/replacement frequency if the hood is used for more than 2 hours a
day. Always use genuine filters from the manufacturer.
03
Lamp replacement
The LED lamps in this appliance are not replaceable by the consumer. If a lamp fails, please contact the Customer
Helpline at the end of Care & maintenance to arrange an engineer visit.
IMPORTANT: Turn off the power after Step 1 below before replacing the carbon filters.
01 Washable lter cleaning
Clean thoroughly once a month or whenever
a banner alerts you to clean them.
To do so, remove the lters and wash with hot
water and detergent. If using a dishwasher
(metal parts may turn black without this
aecting their functional capacity), load the
lters vertically to avoid solid residue from
being deposited.
1 MONTH
WARNING: Always switch o the electrical supply before carrying
out maintenance work on the hood. In the event of a fault,
contact customer services.
Optional
WRWFILT22
Washable lters