08
Safety
TROUBLESHOOTING
Problem Possible Cause Solution
Excessive vibration.
The appliance is not installed
properly on the brackets.
Take down the appliance and check
it is properly xed.
The fan blade is damaged.
Switch o the appliance. Repair to
be carried out by qualied service
personnel only.
The fan motor is not xed
tightly.
The light is on, but the
fan does not work.
The fan blade is jammed.
The motor is damaged.
Both the light and
motor do not work.
Light bulb blown. Contact Customer Services.
Power connection loose. Check power supply.
Suction performance
reduced.
Speed may be too low. Select a higher speed.
Optional vent kit might be
twisted.
Ensure that the vent kit
is tted according to the
manufacturer’s instructions.
Top vent might be
obstructed.
Clear any obstruction.
The installation may
not comply with the
manufacturer's instructions.
The vent hose should be correct
diameter throughout with no
reductions or restriction.
(See installation section).
Works normally but
cooking smells linger.
Carbon lter is not tted in
recirculation mode or is full
of grease.
Fit carbon lter or replace the
carbon lter (See Care and
maintenance section).
The hood does not
work.
Check that the hood is connected to power.
Check the fuse box and trip switches.
The hood still does
not work.
lf, after having checked the points mentioned above, your problem
has not yet been solved, contact Customer Services.
IMPORTANT: If your ceiling hood appears not to be operating
properly, before contacting Customer Services, please refer to the
checklist below.
To Next Page
Loading...