40
12.
Controller
This section specifies the controller which can be either operated by the
occupant or assistant during normal use.
All functions of the wheelchair can be controlled with this joystick module. This
joystick module can be mounted on the left or right armrest. Joystick module
contains a few major components which will be explained separately.
VR2 Controller LiNX Controller
12.1
Charging socket
The charging socket is used to charge the batteries. Whilst charging the
batteries, the driving of the wheelchair is automatically blocked.
12.2
Joystick
The primary function of the joystick is to control the speed and direction of the
wheelchair. The further you push the joystick from the center position the
faster the wheelchair will move. When you release the joystick the brakes are
automatically applied. If the wheelchair is fitted with powered seat functions,
the joystick can also be used to move the specific powered seat function.
The joystick is used to drive the wheelchair. Just push the joystick into the
direction you want to drive, and the wheelchair will start to move in that
direction. (Also refer to the driving technique chapter)
We strongly recommend practicing the function of the joystick before
To Next Page
Loading...
Need help?
General
